Privacy fence?

Question

how do I put up a privacy fence?

Answer 1

Before deciding on style/ price/ etc. you might want to know any restrictions,,,if in fact any exist.

After Miles of fence,,,Privacy might relate to more than one type/style. Often "Stockade" in some type of conifer, or Pvc/Vinyl, and Privacy in those cases usually relates to 6 ft tall x 8 ft. wide panels.

The install; while not as easy as watching it being done, isn't so difficult that a DIY Can't do it.

Depending on any set backs from any property line, posts need to be set first. Some knowledge of the property line allows that you run a cord at whatever length needed, form one corner/end, to another. Then set two posts to establish a LEVEL or GRADE for the remainder/fill in. Obviously those factors of level and property grade will define HOW you install.
Posts of Stockade are usually 4x4x at least 8 ft...but that too might depend on any frost line you experience. The posts should be PLUMB and with a cord stretched at the top of the initial two posts, can either remain level, or be varied in any slope/grade/ etc. I usually allow 24 inch holes, dug with a post hole digger, then add concrete to set and stablize, up to about 6 inches below ground level allowing back fill of soil. The posts in this case should allow,,, that much like house studs, they accomodate the panels ON CENTER. where each panel Butts the previous one. I often screw a piece of lumber just at the place on the 4 x 4 where I can set it at 24 inch (or whatever) allowing some consistency.

After a day I secure the sections,,, using galvanized Decking/fencing screws, appropriate to the thickness of the slats and bracing lumber. 3 inch or longer is my choice. NOT NAILS (in my opinion) I also usually place a piece of lumber on the ground level to keep the slats above ground level. Certainly that assumes a level stretch along the length of the fence.

For the Vinyl/PVC the process is similar, though the hardware may differ.

Steven Wolf

Answer 2

1

Answer 3

Installing a fence will add some much needed privacy to your property, There are a wide variety of options for every budget and aesthetic taste.
Before building your fence check neighborhood rules:
1. Check city codes(Cities often also have rules about building fences)
2. Obtain a permit, Select company to buy or rent fences(Fence Factory Rentals, I found it a best fence provider)
3. Choose your materials(wood fence, Vinyl fences, Brick, Growing or green fences)

Set the Posts:
1. Find post locations
2. Dig post holes
3. Place gravel
4. Place posts
5. Pour in quick-set concrete

Build the Fence:
1. Measure and cut your rails
2. Create your rail frame
3. Fit and attach the frame
4. Attach the outside slats or pickets
5. Attach the inside slats or pickets
6. Add a gate

Answer 4

you can get the plans from home depot ..
but its more or less this..
space out holes in the ground 8 feet apart and about 15 inches deep..
cement in some 6 or 8 foot 4x4 treated wood..
make sure you have them braced off so they stay straight till the mix drys.. about 1 or 2 days..
then connect 2x4's to each pole.. one about 2 foot off the ground and the other about 3 foot from the top.
add the slats one at a time..making sure each one is str8 and evenly spaced

Answer 5

many towns require a permit and approval from either the local building inspector or the planning dept.
do not make a mistake and then they make you take it down.
go to city hall and ask some questions.

Answer 6

Is your backyard next to an elementary school playground?