Easiest way is with one of these.
http://www.screwfix.com/app/sfd/cat/pro.jsp?id=16262&ts=35897
Sticking-out side goes on the trimmer; use a 3-pin version if the trimmer isn't double-insulated. B&Q or similar sell them too.
2007-08-27 06:36:52
·
answer #1
·
answered by Girlie Electrics 7
·
0⤊
0⤋
This Site Might Help You.
RE:
How can I repair the cord of a hedge trimmer I've accidentally cut?
Just been given a new corded hedge trimmer and managed to accidentally cut the cord! It's brand new so don't want to throw it out unless I really have to and need to get the work done in the garden asap so don't really want to take it into a shop.
Can I get a join or a connector to...
2015-08-10 08:59:57
·
answer #2
·
answered by Anonymous
·
0⤊
0⤋
1. If you are in the U.S. you are using 120 volts. 2. 120 volts can kill you if the conditions are right e.g. wet shrubs/ feet 3. You should NEVER use ANY electrical appliance outside or around water inside unless it is plugged into a Ground Fault Circuit Interrupter female plug. Do not trust tools labeled as double insulated - that will not protect you if you cut the cord. 4. You can buy a GFCI protected extension cord but a new GFCI plug in a permanent box is better. An electrician can install a GFCI outlet in minutes and the 20 amp version of the outlet is about $12.00. 5. TIP If you get an electrician he will probably charge you a minimum of 1 hour labor - he can install 2 or three outlets in one hour. One GFCI outlet will provide GFCI protection for up to 4 downstream standard (non GFCI) outlets.
2016-03-17 05:13:34
·
answer #3
·
answered by Stephanie 3
·
0⤊
0⤋
B&q Hedge Trimmer
2016-10-02 02:12:44
·
answer #4
·
answered by holstad 4
·
0⤊
0⤋
I did that with mine on the first day. Doesn't it make you feel a t*t?
If the cut is near the machine, open the machine and remove the (now) short section of wire and rewire the longer bit in. If it is cut in half, you will need new cable. This is a very simple job.
Tip - make a note of which colour wire goes to which terminal as you remove the old cable.
I would not use a block connector for this as the cable is put under a bit of strain in use, best with a complete unbroken cable.
2007-08-27 06:28:11
·
answer #5
·
answered by gaz 3
·
4⤊
0⤋
You will have to open the trimmer up and replace the whole cable. Dont attempt to bodge a repair using wire connecters and insulating tape. Things like that must be thoroughly insulated against moisture and stuff.
2007-08-28 00:25:19
·
answer #6
·
answered by Big kid 5
·
0⤊
0⤋
You should ignore most of these postings as I think some of them are trying to kill you off.
Take your cord etc to a qualified electrician. You won't get a second chance will you. Did you have trip circuit breaker on the appliance by the way. I do hope sp.
2007-08-27 06:56:05
·
answer #7
·
answered by Anonymous
·
2⤊
0⤋
The cable should be completely replaced with another cable of the same square area conductors should not cost more than a few pounds. Do not rejoin the old one you are asking for an electric shock.
2007-08-27 06:52:47
·
answer #8
·
answered by Jase 2
·
0⤊
0⤋
All you need is a roll of vinyl tape and a pair of wire cutters/strippers.
Or, go buy a good (orange) 30 amp, outdoor extension cord.
The electrical tape is obvious, strip the insulation back and attach the wires, twisting them together and taping them INDIVIDUALLY back together, matching the colors.
With the extension cord, disassemble the machine and remove the end of the damaged cord, Cut the female end off the extension cord and attach it to the trimmer.
Oh, and your other half is an a$$hole. Don't do anything for him until he understands accidents happen.
In fact shove that hedge trimmer up his backside and tell him to trim the bushes hisself.
2007-08-27 06:32:37
·
answer #9
·
answered by Anonymous
·
0⤊
5⤋
Yes you can get a proper connector from a DIY shop B & Q in UK // Either a plug together one or a fixed wire one... Make sure it is connected properly though ,,,
2007-08-27 06:27:30
·
answer #10
·
answered by Anonymous
·
3⤊
0⤋