If that yr Yamaha has a removable mid section 5" piece than yes with a new drive shaft. If not than no. Raise the transom 5" or sell as get the correct 1.
2007-08-26 01:59:55
·
answer #1
·
answered by 45 auto 7
·
0⤊
0⤋
It not hard, but, may be expensive. You just remove the lower unit and stem and replace with a shorter. IF, you could find an engine that have a bad power-head (Engine) you may have all your parts. May, be easy then, just remove your power-head and put on the other. Also, this where more research comes in, you may not have to have the same year model, which I feel is very likely. You just need your power-head to have the same bolt pattern.
Here an example to help; Say you have a 1990 Chevy 350 engine. Can you bolt up a 1980 Transmission? Off hand I would say it very possible.
2007-08-25 21:07:01
·
answer #2
·
answered by Snaglefritz 7
·
0⤊
1⤋
Yamaha 5hp Outboard
2016-11-07 05:02:03
·
answer #3
·
answered by Anonymous
·
0⤊
0⤋
I am quite sure you should be able to remove the long shaft leg and replace it with the short shaft leg assembly
2007-08-25 23:26:06
·
answer #4
·
answered by Ian C 2
·
0⤊
0⤋
possible but cost prohibitive.
2007-08-26 02:08:15
·
answer #5
·
answered by Anonymous
·
0⤊
0⤋