At times the inside door switch to lock the doors doesn't work, and then at anytime it will just start clicking again. Do you have any suggestions?
2007-08-25 13:33:17 · 5 answers · asked by debi z 1 in Cars & Transportation ➔ Car Makes ➔ Honda
the door lock actuator is going bad. It is cycling between lock and unlock as the magnetic solenoid is breaking down.
you will need to have the door lock actuator replaced. It is usually limited to one door only and it typically runs about $150 to replace the bad actuator.
hope that answers your question
2007-08-25 15:16:52 · answer #1 · answered by honda guy 7 · 0⤊ 0⤋
A Lincoln is cooler than your civic additionally to be severe one time I had a motor vehicle that had a fender pushed slightly back and it could bend slightly and click whilst my door opened I merely had to pass the panel over like a million/sixteen of an inch merely adequate that i did now not choose new holes and it mounted it ok
2016-12-31 05:44:14 · answer #2 · answered by ? 3 · 0⤊ 0⤋
when i had a '00 civic that would sometimes happen to me when it was very cold. also, it would happen if i went a bit overboard at the car wash. water would get on the connections inside the door.
when that happened i would use the key to unlock the driver's door and it would fix itself. i never had to have any actuators fixed, but that could be the problem you face.
any good auto service tech could check it out for you. maybe you have a bad connection or one of the components is really bad.
2007-08-26 01:33:26 · answer #3 · answered by mycle1000 5 · 0⤊ 0⤋
This happened in my car, and I found that a fuse had blown. Bring it to a garage, and tell them to look at the fuses, or if you can change fuses, then you can do it!
2007-08-25 13:38:05 · answer #4 · answered by M S 2 · 0⤊ 0⤋
usually it real expensive. just deal wit it
2007-08-25 13:39:50 · answer #5 · answered by mike L 2 · 0⤊ 0⤋