Most lawnmowers are 4 stroke engines requiring straight gasoline, It is possible, though not very likely, that it could be a two-stroke, requiring a mixture.
2007-08-25 12:02:05
·
answer #1
·
answered by MontyH 5
·
0⤊
0⤋
A lawnmower is just like your car. You put gas in the gas tank and oil in the oil reservoir. You will find a cap usually marked "oil" which screws off to check the oil level. Depending on the type of mower you have, this cap may or may not have a dip stick attached. If you have a dip stick, screw the cap off, wipe off the oil, screw it back in, and unscrew it again to check the oil level. On some motors the oil cap is near the bottom of the motor, close to the metal mower deck. If this is the case, you will not have a dipstick, just fill the oil reservoir until it is full, but not running over.
Use regular unleaded gas.
2007-08-25 12:18:19
·
answer #2
·
answered by Mark T 4
·
1⤊
0⤋
Most lawnmowers use regular unleaded gasoline. It will usually say on the cap of the gas tank whether you need to add oil or not. (most likely not). Most lawnmowers have a different place where you place in the oil.
2007-08-25 12:02:36
·
answer #3
·
answered by emanyio712 2
·
0⤊
0⤋
Simple question for your answer. How many caps are there? If there are 2, its a 4 cycle motor, and oil goes in one and gas in the other. If there is only one, then its a 2 cycle and requires a gas and oil mixture. Please check the owners manual for the proper mix ratio.
2007-08-26 02:54:51
·
answer #4
·
answered by Todd B 5
·
1⤊
0⤋
90% sure its only gas but you can always look if it has a seperate spot for oil then it does not take a gas oil mixture so if you see another place for oil check it make sure it is at the right spot on the dipstick and just add normal gas to it
2007-08-25 12:02:41
·
answer #5
·
answered by d s 3
·
0⤊
0⤋
There should be a label on the engine that provides oil instructions. More than likely it uses gas and oil separately, but there is a slight chance it's a two-cycle engine which mixes gas and oil.
2007-08-25 15:32:48
·
answer #6
·
answered by Anonymous
·
0⤊
0⤋
I remember doing this before I changed to electric. You mix a few drops of oil into the gas. It was messy and clumsy.
----------------
Here is the recommended formula.
mixture of unleaded gas and 2-stroke oil. Mix the fuel and oil in the convenient mixing container so you get the exact fuel to oil ratio of 25:1.
-------------------------
Wow, do some people actually measure that proportion?
2007-08-25 12:10:25
·
answer #7
·
answered by QuiteNewHere 7
·
0⤊
0⤋
it is going to easily shelter the subject via itself and the surplus oil would be thrown off and burned. The oil could have spilled over into the air intake pipes. i do no longer have faith it is going to break it yet returned, it is not going to help it. My uncle pronounced years in the past whilst he substitute right into a boy, oil and gas had to be mixed jointly for the lawnmower. He pronounced sometimes they further slightly greater desirable oil to make it smoke to kill the ticks and chiggers
2016-11-13 09:59:36
·
answer #8
·
answered by deperte 4
·
0⤊
0⤋
if it,s a 2 cycle add oil to gas, 50 to 1 mix
if it,s a 4 cylcle just gas, should tell you on the lable on mower, another way to tell is look for a oil dip stick, if it has one it,s a 4 cylcle
2007-08-25 12:03:04
·
answer #9
·
answered by William B 7
·
0⤊
0⤋
no!!!oil in gas,,,oil goes in crank case, should be a square head or two little flangs stickin up ,to take off and apply oil<>IS<>, this b at base of motor(OUTSIDE)
2007-08-25 12:05:55
·
answer #10
·
answered by THE"IS" 6
·
0⤊
0⤋