The core piece is still available and I could replace that there is just the area around the core and the existing wall that was removed by the bit... I have heard of pressure injection. Is this the only way. the hole is about 12 inches deep.
2007-08-23 14:45:02 · 4 answers · asked by Jeremy J 1 in Home & Garden ➔ Maintenance & Repairs
fill the hole 1/3 to 1/2 way with a good liquid sealant,
[like an epoxey ]
lower the core into the hole, allow the sealant to ooze up the sides, apply some weight or pressure to the core, smooth out any excess before it hardens,
2007-08-23 14:57:09 · answer #1 · answered by William B 7 · 0⤊ 0⤋
There some epoxy based concrete products I would say can be used to get it back into place. I also would try to make sure you put fill and tamp the location underneath so it doesnt settle..........Good Luck
2007-08-23 14:52:23 · answer #2 · answered by mlk682 3 · 1⤊ 0⤋
fill part of it with stones, then buy a cement called dry-lock,you mix it a little at a time it dries fast,till you patch the hole.
2007-08-23 14:52:30 · answer #3 · answered by luka 5 · 1⤊ 0⤋
hydralic cement
2007-08-24 00:48:48 · answer #4 · answered by biloguide 4 · 0⤊ 0⤋