Hi I am going to install a pedestal sink in my bathroom, however, aside from the screws that anchor the sink to the wall, is there any other sealant/caulk/glue I should buy that will ensure that the sink adheres properly to the wall so that it is firm and rigid (so it doesn't wobble while turning on the faucet etc)?
2007-08-17 20:17:22 · 5 answers · asked by thejollibengali 2 in Home & Garden ➔ Do It Yourself (DIY)
Silicon sealant - but the fixtures should hold it solid really; the sealant only stops water going where it shouldn't!
2007-08-17 20:22:39 · answer #1 · answered by Sal*UK 7 · 2⤊ 0⤋
plumber here... you do have to cut the drain shorter, whatever it takes, hopefully, you have plastic drain lines PVC(white), or ABS(black). that will make it a lot easier to just cut @ 1" from the wall and glue on a 1 1/2" female trap adapter..(most stub out's are inch and a half). now if you have galvinized pipe you'll probably have to cut the wall open b/c any clamp will stick too far out. you can make a little hole in wall next to pipe, and look in the wall w/ a flashlight, you may be able to unscrew and put a smaller nipple......once you got that, set the pedestal up(w/ faucet & pop-up allready on) & carefully slide it to wall, mark your holes on the wall(on each side under bowl). if there is wood in the wall to screw to use double threaded bolts w/ nuts and washers. if its just sheet rock use toggle bolts. it'll be a little tricky, but don't completely tighten the bowl to the wall w/o the pedestal under. i usually put the pedestal under and ****** to the side so you can easily hook up the drain, HOPEFULLY THIS HELPS, good luck
2016-05-22 01:11:19 · answer #2 · answered by araceli 3 · 0⤊ 0⤋
The anchors should hold the bowl firmly to the wall. Use silicone caulk around the edge to prevent water from going between the bowl and wall if splashed.
2007-08-18 03:41:03 · answer #3 · answered by sensible_man 7 · 0⤊ 0⤋
If you position it correctly you shouldn't have a problem. However that was not your question. The product, "liquid nails" is an adhesive that you would have to pull the wall out to remove it. If you don't want your sink to move, I suggest this product. There are other adhesives that are effective, but not as much as this one. Bear in mind that once this sets, it will not move. If you choose to change it in the future, it will take the drywall with it.
2007-08-17 20:24:59 · answer #4 · answered by Boomer 5 · 1⤊ 2⤋
If secured properly it will not move.To fill small gap between wall and basin use white mastic in a mastic gun then wipe lightly with damp sponge.
2007-08-17 21:48:44 · answer #5 · answered by z900a4 3 · 0⤊ 0⤋