i need help with my jacuzzi.?

Question

i have all the chemicals i need to balence it out i just need to kno where to put the chemical and how much of it
i have strips that measure
ph
bromine
total alkalinty
and i think calcium

Answer 1

you put it right into the water.they give you measuring cups and you dump it in.te most important thing you have to remember about PH is to make shure your TA is where it should be .this will stabilize it so you dont have big fluxuations.mabey you should take a look at this water chemistry site before you start dunping chemicals in you tub.
http://www.spacare.com/index.asp?PageAction=Custom&ID=11

Answer 2

Nobody else mentioned this, but turn the pump on at low speed with the air intakes closed, before adding the chemicals. This will help dissolve and mix them into the water. As for the rest, follow your friendly pool store clerk's directions, as well as the ones on the containers. There is a specific order you should use.

Answer 3

Any pool supply store should be able to tell you what to do. The amount of chemicals depends on the size of the jacuzzi and the condition of the water according to your tester. I used to have a swimming pool, it takes a little bit of practice and experience like everything else.

Answer 4

You put the chemicals in the water, I just dump them right in the center of the tub. How much depends on the volume of water and the amount of change needed. Trial and error for us over the years.

Answer 5

You put the chemicals directly in the water and the containers will give you specific amounts depending on the size and water capacity of you tub.

Answer 6

You put the chemicals directly into the water.