What should the front rotors be torqued to?
2007-08-16 16:21:31 · 5 answers · asked by Curious George 4 in Cars & Transportation ➔ Car Makes ➔ Acura
steel wheels, 80 ft pounds of torque
aluminium wheels, 90 ft pounds of torque and recheck after 100 miles or so
2007-08-16 16:27:05 · answer #1 · answered by Christian 7 · 0⤊ 1⤋
If rotors are warped or worn too skinny they want substitute. in the event that they are real and think of sufficient it can be a waste of time and funds to swap them. Rotors must be became to insure maximum appropriate scuffling with. you ought to flush and bleed the brake strains to eliminate air and condensation that can corrode the brakes interior and lead them to leak. Bleed each and all of the brakes, not purely the front. in case you % to alter the rotors to be sure pertaining to to the same old, reliable. circulate forward and do it. I particularly have replaced brake pads and left the rotors on my own and suffered no loss of braking effectiveness, yet it particularly is basically me.
2016-12-15 17:33:47 · answer #2 · answered by ? 4 · 0⤊ 0⤋
for the rotor retaining screws, i would just hand tighten them with a screw driver. I tossed mine, because you usually need a hand impact tool or air tools to get it off. The wheel will hold the rotor on like most cars do. I haven't noticed any adverse effects.
2007-08-17 18:58:33 · answer #3 · answered by Corey the Cosmonaut 6 · 0⤊ 0⤋
If you're talking about the countersunk philips screws, 7 ft lbs. Make sure you use antisieze on them.
2007-08-16 19:50:19 · answer #4 · answered by stolsai 5 · 0⤊ 0⤋
80 ft lbs
2007-08-16 17:51:00 · answer #5 · answered by Anonymous · 0⤊ 1⤋