I don't think it is "sweat" as I don't see any moisture on the bowl itself, just at the very base, where the toilet meets the floor. Is it possible the seal is leaking? Would moisture appear here if this was the case? If so, is this a big project to fix the seal myself, or should I have a plumber do it? Thanks
2007-08-15 13:48:42 · 5 answers · asked by Penny P 5 in Home & Garden ➔ Maintenance & Repairs
This is a relatively simple DIY repair and a fun project. Check out the below website and you will know how to do it yourself and save some money.
BUT one warning.... Do not over-tighten the nuts on the base of the toilet as you could crack the toilet. Also when seating the toilet to the wax ring make sure the toilet seats well. (SMile) Sit on the toilet and "SLIGHTLY" wiggle around to insure a good seal between the pipe and the base of the toilet..
Wax rings can be obtained at home Depot.
2007-08-15 15:03:49 · answer #1 · answered by Anonymous · 2⤊ 0⤋
It is not all that hard. You will have to take the entire unit up off the floor. Also , you will have to disconnect the water supply line. Turn off the water, flush the toilet, mop the remaining water out of the tank. Remove the two nuts on either side of the base, they can be rusted and difficult to remove. You can cut them off with a dremel tool. Raise the unit and set it aside. You will have to clean the seating surface of the floor flange and put in a new wax gasket. It will come with new bolts and nuts. Set the toilet back on the floor flange by aligning the bolts to the holes. Tighten the nuts onto the bolts but not so tight as to crack the base. Reattach the supply line.
2007-08-15 21:03:15 · answer #2 · answered by renpen 7 · 0⤊ 0⤋
you need a new Ring/sealing gasket underneath. Buy a kit, which will include new bolts for the sides, and the ring. Remove the toilet, pull out the old one and the old screws on the sides.
Put on the new one, put down the new screws, and replace the toilet. Do not overtighten the screws-make them snug. Use white or whatever color caulk around the edge, and clean up with a wet sponge.
2007-08-19 20:23:20 · answer #3 · answered by jim1965_99 3 · 0⤊ 0⤋
Its real easy. Go get a "wax ring." Shut the water off to the toilet and flush the water out. Next unbolt from the floor remove old ring and place new ring on base. Put the toilet back into place bolt back down and enjoy.
2007-08-15 22:52:52 · answer #4 · answered by k.c. k 1 · 0⤊ 0⤋
it may be running from spud gasket,located between tank and bowl,or early sign of sewer blockage.
2007-08-16 10:43:05 · answer #5 · answered by tom the plumber 3 · 0⤊ 0⤋