I just rebuilt mi top end on mi blaster...piston..gaaskets..i rode it for liek 5 days and while i was at the botom of 6th gear the quad died outa nowere...but be4 it died it felt like somthin was holding the quad back alot so i pulled in theclutch..rode it out then when finaly stoped the kcikstart would move liek an inch and no ferther
does any1 no wats might be rong with it?
2007-08-12 08:21:21 · 7 answers · asked by Anonymous in Cars & Transportation ➔ Motorcycles
If you installed the piston backwards, the ring end gap would get stuck in one of the cylinder ports.
But that should've happened right away.
If one of the pins on the piston broke off, one of the rings would spin around on the piston and get stuck in a port.
You could have run out of injector oil, or the oil pump stopped working, or the oil line came off and the top end seized.
Whatever caused the problem, remove the cylinder and check out the top end.
2007-08-12 08:42:50 · answer #1 · answered by guardrailjim 7 · 0⤊ 0⤋
This Site Might Help You.
RE:
the kickstart on mi newly rebuilt top end yamaha blaster wont move?
I just rebuilt mi top end on mi blaster...piston..gaaskets..i rode it for liek 5 days and while i was at the botom of 6th gear the quad died outa nowere...but be4 it died it felt like somthin was holding the quad back alot so i pulled in theclutch..rode it out then when finaly stoped the kcikstart...
2015-08-15 08:35:48 · answer #2 · answered by Anonymous · 0⤊ 0⤋
put the bike in 5th or 6th gear and try to roll it see if the motor turns over at all if it does then there is nothing wrong with the top end that is locking it up something in the trans maybe. because the head gasket is copper u can reuse it so maybe pull the head off and see where the piston is and see if it moves look for scaring on the cylinder walls. If you have any other questions email me i have worked on many blasters over ten years motorcycle mechanic
2007-08-12 08:55:02 · answer #3 · answered by Jeremy P 2 · 1⤊ 0⤋
Did you remember to put oil in it? It sounds like it's seized.
2007-08-12 16:37:43 · answer #4 · answered by Anonymous · 0⤊ 0⤋
take it apart again and find the problem, your gonna have to anyway. If your smart enough to do a top end how come you ask a STUPID question!!!
2007-08-12 10:09:55 · answer #5 · answered by Anonymous · 1⤊ 2⤋
sounds like it seased to me
2007-08-12 09:13:44 · answer #6 · answered by g.blakeney 1 · 0⤊ 0⤋
chopperchopster, you are a dick. If you don't like his question then ignore it!
2007-08-12 17:25:13 · answer #7 · answered by Dani&Morgan 5 · 1⤊ 1⤋