I cant get into my wireless routers settings?

Question

I have a linksys router and I need to get into the settings. I know to do this you need the IP address, and Ive one it successfully before, but for some reason now it's not working. When I go to the IP address the page won't load. Help?

Answer 1

Two things you can try.

1. Open up a dos prompt (Start >Run > type cmd > OK)
and type IPCONFIG /ALL
and the Gateway IP is the IP of the router.

2. Default the router to factory settings.

There should be a little hole on the back of the router.
Insert a paper clip and hold it in for 15 seconds then turn off / on the router.

Answer 2

You can go to the linksys website and get step by step instructions on how to do that. Im not sure exactly what to tell you since I don't know the model you have. Here is a link to linksys tech support. Hope this helps.

http://www.linksys.com/servlet/Satellite?c=L_CASupport_C1&childpagename=US%2FLayout&cid=1166859677881&pagename=Linksys%2FCommon%2FVisitorWrapper&lid=7788135000H10

Answer 3

on your PC go to Start > Run > type IPCONFIG /ALL get the default gateway then type that in to your browser. I believe the default password for linksys is no username and admin for password

Answer 4

start-->run-->cmd-->ipconfig( note down default gateway address)
open internet explorer and type in the address bar as-->192.168.1.1
username:(leave the username blank)
password: admin(in lower cases)[ this is the default password and if you had changed type that password]

if not able to login to the setup page....

start-->run-->cmd--> ping 192.168.1.1
if you get replies then you will surely connect...
else try power off-on...

Answer 5

try switching the wireless switch on the computer on if you dont have a wireless computer you can buy a wireless usb adapter or pci card ad connect it through your router on to the modem

Answer 6

Mine's IP address is 192.168.1.1
logon admin
password admin

Answer 7

In order to get into your router, you should type in 192.168.0.1 and then your username and password. The default would probably be

Username: admin
Password: password

or

Username: admin
Password: admin

I hope I helped you!

Answer 8

first you will need to hard wire your computer to the router by cat5 cable, then follow Jamie's instructions.