How to put on vinyl tiles?

Question

I want to put vinyl tiles on my pre-existing ceramic tiles but in some areas there is no ceramic tiles and I need something to fill in the gap to make my floors even when I put on the vinyl tile. What should I use? Then when my floors are even how do i put my tiles?

Answer 1

With all due respect; that wasn't a good idea to begin with. If asked I'd turn down the job.

First of all the grout lines should have been considered; and the depression that exists. I'll assume you intend to BUTT each sticky tile to any other. At some pint; some portion of that will come in contact with grout lines. In a normal process of just walking on the vinyl tiles; the grout lines will become evident; under the vinyl.

Essentially a glazed ceramic tile is glass; and is not pourous, or even designed to adhere anything to it.

For a transition area you could either install more tile first, or fill the transition; perhaps even feathering it? Without knowing the WHERE of the gaps; it may not be aesthetically suitable in any case.

To more directly answer your Q; but so much "not" if favor of stick on anything; I offer this. I do it or suggest it every time.

Get a can of contact cement; regular base or water base.

Peel the paper from the back of each tile.

Brush or roll contact cement to the back of the tile as well as the surface to be covered.

Let air dry, then stick, press, and hope.

Steven Wolf

Answer 2

If you insist on installing vinyl tiles over the ceramic....first you need to abrade the surface of the ceramic, then you need a high quality floor leveler, such as Ardex to skim over the entire floor and fill in the grout joints.

In the areas without tiles, you can use plywood to build up to the level of the existing tile. Make sure to skim over the plywood joints as well.

Hopefully, you are not using the peel and stick tiles, because over time they do not stay stuck to the floor. Use the dry back and put the adhesive on the floor, and the tile in the glue.

Just remember - your new floor is only as good as the floor under it...best to rip up the ceramic.

Answer 3

Depending on what vinyl tiles you buy, it's best to follow manufacturers instructions. If not, contact the vinyl tile company to make sure what is the best method to use lay your vinyl tiles down.

Hence ceramic tiles does have very deep grout lines and may or may not have scratches or depressions in it. You should use an embossing leveler to level out the floor. Use it according to manufacturer's instructions.

Secondly, it's best to use a primer. Hence a latex primer is always good. But depending on the tile, if you are purchasing a self-stick tile or regular vinyl tiles. The brand of vinyl tile always recommends you to use a certain type of primer that allows the glue to adhere better. Then you won't have any tiles popping up.

Answer 4

To make an even floor with lost or break tiles, if you are not interest to demo late floor the most wise way is to use mortal concrete for places that there's no tile and after 4 hours that concrete get to gather make a liquorish (but not too liquid like juicer concrete ) and with on broom apply all cross of the tiles to making even between the tiles (grout is always lower than tile surface) After this operation when complete concrete get dried . Apply special glue comes with tiles (Ask when you going to buy tiles) and install your tiles ,do not let adhesive get hard and install your tile fast as you can or apply adhesive just in point that you are working on .

Answer 5

well you dont put anything over ceramic tile you rip it up after that then will talk

Answer 6

good luck