If I knew which wires went to trim, rpms,engine hours,ect... I could follow them. The engine wiring harnes is stil intact, but I dont know which wire goes to each no matter which end I look at. Like I said wiring is no problem, don't know motors.
2007-08-05 03:40:44 · 3 answers · asked by Anonymous in Cars & Transportation ➔ Boats & Boating
Tis is a 90 horse mercury engine, the boat has no gauges. I guess if I buy mecury gages the wiring color will match the harness.
2007-08-05 04:22:15 · update #1
Look at the guage the sender wire color same color on the Eng.tack is gray,hours meter is from the key switch 12volt red or purple. trim is manufactures colors.Are you wiring the Eng like install if so most are plug in . Unless it's quite old an then there labeled on the Eng.
2007-08-05 03:47:32 · answer #1 · answered by 45 auto 7 · 0⤊ 0⤋
get a repair manual.in the back it will give you the wiring diagram for everything on your car the color codes too. you will spend some time matching them up but at least you wilol know what is what
2007-08-05 03:47:49 · answer #2 · answered by Anonymous · 0⤊ 0⤋
trim is dark brown with white trace. tach is gray. why do you need an hour meter? purple is switched power. black is ground. black with yellow trace is kill. yellow with black trace is choke/primer. yellow with red trace is solenoid/starter. now, let me hold a dollar big man.
2007-08-06 03:51:40 · answer #3 · answered by Anonymous · 0⤊ 0⤋