I recently bought a 2nd hand boat with a suzuki DF 140hp 2004 model and the trim gauge is not working. I have 12v at the gauge when I turn on the ignition. When I ground (ie earth)out the sender wire the gauge needle moves from 'fully down' to 'fully up'. So, I figure the problem is with the sender - any ideas on how I can troubleshoot this problem?? Thanks in advance. Tim
2007-08-05 01:08:07 · 3 answers · asked by Tim 65 1 in Cars & Transportation ➔ Boats & Boating
Check on the intermediate housing where the Eng pivot's there should be a switch the moves when Eng lifts. these don't seem to last long Follow the wires near the trim pump?
2007-08-05 01:49:31 · answer #1 · answered by 45 auto 7 · 0⤊ 0⤋
the trim sending unit has gone bad on every outboard thet i have owned, but. they're easy to replace .
2007-08-05 03:13:34 · answer #2 · answered by Anonymous · 0⤊ 0⤋
complex stuff. research using a search engine. that can assist!
2014-11-04 19:18:40 · answer #3 · answered by Anonymous · 0⤊ 0⤋