How to split connection (50/50) with router?

Question

Hello. I have a wireless router and DSL, 4mbits. I have a pc and a laptop. Now, I would like to split connection, so the pc and the laptop could connect to the internet, 2mbits each. How can I do this. Because when I'm downloading something on the pc, connection on the laptop is like 100 kbps. I was looking in my router configuration, but I didn't see anything that would do what I need.

Does anyone know the answer?

Answer 1

your cheapest solution will be to find a 3rd part software application that will accomplish that. it can't be done via hardware with the networking equipment that you have currently.

Answer 2

The router does not have the means to do what you want. If you want to disconnect the wireless completely and run wired connections, you can install a managed switch, assign separate vlans, and allocate bandwidth to each vlan. This is a pretty costly thing to do with only 2 pcs.

I suspect you problem is deeper than that. If you have a 4 Mbps speed and you are getting 100 Kbps you probably have freeloaders hacking at the bandwidth. You should measure the internet speed with wireless shut off and only 1 pc hard wired to the router. If it is at or near 4 Mbps in this case and at 100 Kbps with wireless active, you clearly have hackers hogging bandwidth - and you must install security to keep them off. On the other hand if with a single wired connection you have 100 Kbps, call the ISP as something is foul.

Answer 3

Do not split the connection but basically create 2 connections with a "switch" a good switch will allow up to 10 seperate IP adresses which means while using one you will not affect the other connections.

Answer 4

disconnect the router and test the speed of the pc directly connected to the DSL modem. If it is running at 4M and then when you reconnect the router the desktop or laptop is running at 100kbs you have jerks for neighbors. They are freeloading off of your wireless connection and hogging your bandwidth. Enable security and only allow your laptop's IP addr to connect to the router wirelessly. You are paying for your ISP not them!!!

Answer 5

monitoring use on the LAN point is economically impractical. expenditures for such kit are considerable because of the fact they are designed to be utilized by potential of ISPs that grant subscriber based service. those are RADIUS servers (RADIUS initially ment "distant get admission to dial up service" and used for use interior the dial up ISP days; later dial up grew to become a loose term for any form of "hyperlink up"; RADIUS servers could be utilized to regulate get admission to, can charge for use time, can charge for potential (volume of information transferred), etc. mutually as those exist, you will discover them thank you to high priced to purchase, deploy, and use on your case. you're extra appropriate off utilising the diplomatic attitude with your clientele. Your router assigns LAN (deepest or non-routeable IP addresses) by means of Dynamic Host Configuration Protocol (DHCP) and those are called Dynamic IP addresses, no longer computerized IP. on your peer to work out community the router assigns the LAN IP addresses. in evaluation to the advice of different responders you have dynamic LAN IP addresses already and this does not allocate or administration bandwidth. you need to have a router and you could't replace a router with a community swap. this does not administration bandwidth and no unmanaged swap does. on your case the modem and router and a 4 port swap are integrated right into a unmarried equipment. in case you have extra effective than 4 LAN gadgets, you could upload a swap and plug it into between the 4 router LAN ports.