English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories
0

Before i go to sleep i usually pull off the plug of my computer. But then recently i encountered this problem that whenever i leave my computer unsocketed for hours it just doesnt seem to turn on right (no power at all).. I keep on pressing the power button but it just does not seem to work.. Now all i do is keep the plug socketed for it to be useable.. i cant keep it like that. what if it gets worse, i need help?

2007-07-23 09:26:58 · 5 answers · asked by Eon 2 in Computers & Internet Hardware Other - Hardware

5 answers

if I read this question literally, I would say that u are talking about a laptop and the battery is bad.

IE, u leave it "unsocketed" - u don't mention that u plug it back in.
therefore after a short while the battery is dead.

If u leave it "socketed" then it runs fine from AC power.

Now if that is not the case, then the question is - how do u eventually get it to turn on?

this answer may lead to a Motherboard or Power supply issue.

2007-07-23 10:20:53 · answer #1 · answered by Bill R 7 · 0 0

When you plug in your PC, do not hit the power button immediately. Wait for 30-60 seconds, then power ON. That should do it. Some power supplies with large capacitors and inductors take a while to initialize.

2007-07-23 12:42:53 · answer #2 · answered by Karz 7 · 0 0

If you pull the plug from the cord rather than from the plug, you may have damaged the copper wires. Since computer power cords are pretty generic, try using one from another computer for a while and see if it cures the problem.

2007-07-23 09:42:14 · answer #3 · answered by The Phlebob 7 · 0 0

they're all on the troublesome force which you would be able to take out and put in an exterior troublesome force enclosure.it could have merely fried your capacity grant and additionally you gets it up and working for below $one hundred.Get a much better surge protector.good success

2016-10-22 11:11:08 · answer #4 · answered by alpers 4 · 0 0

ok other than the fact its damaging, you may have short circuited some wires. Also if you continue to do this some of your RAM may recieve faults from the binary transfer everything will be set to 0 to quickly and well BO0m

2007-07-23 09:56:31 · answer #5 · answered by Matt Murdock 2 · 0 0

fedest.com, questions and answers