English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

7 answers

all I can tell you it's a metric, probably 15 mil.

2007-07-21 14:39:04 · answer #1 · answered by mister ss 7 · 0 0

Hi Yes you can measure the socket required bolt heads are measured across the flats that is a bolt head is hexagonal just measure from one flat side across the bolt to the other flat side the bolt holding the blade on my mower is about 32mm across the flats and allthough i have large collection of spanners this one is a bit big i allways use a monkey wrench or large adjustable spanner these are much cheaper than a socket ,just make sure it is nice and tight on the bolt then a gentle tap with a hammer and it should come undone ok take a picture on your phone before dismatling the blade just in case as sometimes its not obvious which way up things are , i take my blade off once a year to sharpen it , best of luck regards ward

2016-05-18 23:31:27 · answer #2 · answered by ? 3 · 0 0

nearly all later model GM products take a 15mm socket for the drain plug. the 87 should fall in the same size range

2007-07-20 15:40:49 · answer #3 · answered by gary d 3 · 1 1

15 or 17 mm.

2007-07-20 16:02:57 · answer #4 · answered by Anonymous · 0 0

try a crecent wrench

2007-07-20 15:41:25 · answer #5 · answered by cheyenne95129 3 · 0 2

9/16th's or 5/8'ts

2007-07-20 15:39:18 · answer #6 · answered by duster 6 · 0 1

5/8th inch.

2007-07-20 15:39:25 · answer #7 · answered by Stuart 7 · 0 1

fedest.com, questions and answers