Is there really such thing as quick sand?

Question

Where does it exist?

Answer 1

Well yes. But the dramtic quick sand that sinks you under ground in less than a minuet has yet to be found. Not saying it doesnt exist, I just highly doubt it. That is often seen in hollywood movies or shows.
Mythbusters is a (very very good) show on discovery channel. Once they did a myth about the killer quicksand and could not come up with it. So THEY say it's 'busted' or not existant and they are experts.
If it did exist though it would probobly be in some remot place in the rainforest that we have yet to walk through.

Answer 2

Quicksand is a colloid gel consisting of fine granular matter (such as sand or silt), clay, and salt water. The origin of the name refers to "quick" in the older meaning of "alive" rather than "fast," and is thus similar to the origin of the term quicksilver for mercury.

When undisturbed it often appears to be solid, but a minor (less than 1%) change in the stress on the quicksand will cause a sudden decrease in its viscosity. After the initial perturbation—such as a person attempting to walk on it—the water and sand in the quicksand separate and dense regions of sand sediment form; it is because of the formation of these high volume fraction regions that the viscosity of the quicksand seems to suddenly increase. In order to move within the quicksand, a person or object must apply sufficient pressure on the compacted sand to re-introduce enough water to liquefy it. The forces required to do this are quite large: to remove a foot from quicksand at a speed of one centimeter per second would require the same amount of force as "that needed to lift a medium-sized car." [1]

It was commonly believed that the behavior of quicksand was due solely to saturated or supersaturated suspensions of granules in water. Pressure from underground sources of water would separate and suspend the granular particles, reducing the friction between them. As of September 2005, it has been shown that it is the presence of salt that is largely responsible.[1] The stability of the colloidal quicksand is compromised by the presence of salt, increasing the likelihood of sand flocculation and the formation of the high viscosity regions of sediment responsible for quicksand's "trapping" power.

Quicksand can be found inland (on riverbanks, near lakes, or in marshes) or near the coast. It can also form when an earthquake increases groundwater pressure, forcing the water to the surface and causing soil liquefaction.

One region notorious for its quicksands is Morecambe Bay, England. As the bay is very broad and shallow, a person trapped by the quicksand would be exposed to the danger of the returning tide, which can come in rapidly.

Answer 3

Quicksand is a colloid gel consisting of fine granular matter (such as sand or silt), clay, and salt water. The origin of the name refers to "quick" in the older meaning of "alive" rather than "fast," and is thus similar to the origin of the term quicksilver for mercury.

When undisturbed it often appears to be solid, but a minor (less than 1%) change in the stress on the quicksand will cause a sudden decrease in its viscosity. After the initial perturbation—such as a person attempting to walk on it—the water and sand in the quicksand separate and dense regions of sand sediment form; it is because of the formation of these high volume fraction regions that the viscosity of the quicksand seems to suddenly increase. In order to move within the quicksand, a person or object must apply sufficient pressure on the compacted sand to re-introduce enough water to liquefy it. The forces required to do this are quite large: to remove a foot from quicksand at a speed of one centimeter per second would require the same amount of force as "that needed to lift a medium-sized car."

It was commonly believed that the behavior of quicksand was due solely to saturated or supersaturated suspensions of granules in water. Pressure from underground sources of water would separate and suspend the granular particles, reducing the friction between them. As of September 2005, it has been shown that it is the presence of salt that is largely responsible. The stability of the colloidal quicksand is compromised by the presence of salt, increasing the likelihood of sand flocculation and the formation of the high viscosity regions of sediment responsible for quicksand's "trapping" power.

Quicksand can be found inland (on riverbanks, near lakes, or in marshes) or near the coast. It can also form when an earthquake increases groundwater pressure, forcing the water to the surface and causing soil liquefaction.

One region notorious for its quicksands is Morecambe Bay, England. As the bay is very broad and shallow, a person trapped by the quicksand would be exposed to the danger of the returning tide, which can come in rapidly.

Answer 4

Quicksand is a colloid gel consisting of fine granular matter (such as sand or silt), clay, and salt water. The origin of the name refers to "quick" in the older meaning of "alive" rather than "fast," and is thus similar to the origin of the term quicksilver for mercury.

When undisturbed it often appears to be solid, but a minor (less than 1%) change in the stress on the quicksand will cause a sudden decrease in its viscosity. After the initial perturbation—such as a person attempting to walk on it—the water and sand in the quicksand separate and dense regions of sand sediment form; it is because of the formation of these high volume fraction regions that the viscosity of the quicksand seems to suddenly increase. In order to move within the quicksand, a person or object must apply sufficient pressure on the compacted sand to re-introduce enough water to liquefy it. The forces required to do this are quite large: to remove a foot from quicksand at a speed of one centimeter per second would require the same amount of force as "that needed to lift a medium-sized car." [1]

It was commonly believed that the behavior of quicksand was due solely to saturated or supersaturated suspensions of granules in water. Pressure from underground sources of water would separate and suspend the granular particles, reducing the friction between them. As of September 2005, it has been shown that it is the presence of salt that is largely responsible.[1] The stability of the colloidal quicksand is compromised by the presence of salt, increasing the likelihood of sand flocculation and the formation of the high viscosity regions of sediment responsible for quicksand's "trapping" power.

Quicksand can be found inland (on riverbanks, near lakes, or in marshes) or near the coast. It can also form when an earthquake increases groundwater pressure, forcing the water to the surface and causing soil liquefaction.

One region notorious for its quicksands is Morecambe Bay, England. As the bay is very broad and shallow, a person trapped by the quicksand would be exposed to the danger of the returning tide, which can come in rapidly.
------------------------------------------------------------------------------------

Inside This Article
1. Introduction to How Quicksand Works
2. What's Quicksand?
3. How to Escape
4. Lots More Information
5. See all Earth Science articles

How many times have you watched a movie where the hero is sucked down into a pit of quicksand, only to be saved at the last minute by grabbing a nearby tree branch and pulling himself out? If you believed what you saw in movies, you might think that quicksand is a living creature that can suck you down into a bottomless pit, never to be heard from again. But no -- the actual properties of quicksand are not quite those portrayed in the movies.

With quicksand, the more you struggle in it the faster you will sink. If you just relax, your body will float in it because your body is less dense than the quicksand.

Quicksand is not quite the fearsome force of nature that you sometimes see on the big screen. In fact, quicksand is rarely deeper than a few feet. It can occur almost anywhere if the right conditions are present. Quicksand is basically just ordinary sand that has been so saturated with water that the friction between sand particles is reduced. The resulting sand is a mushy mixture of sand and water that can no longer support any weight.

If you step into quicksand, it won't suck you down. However, your movements will cause you to dig yourself deeper into it. In this article, you will learn just how quicksand forms, where it's found and how you can escape its clutches if you find yourself hip-deep in it

Answer 5

Yes, in South America.

Answer 6

Yep, it's a mixture of sand, clay, and I think saltwater. It looks like solid ground but when you step on it, it sinks! My grandfather stepped into some during the war, his friend pulled him out with a sturdy branch :)

Answer 7

I remember seeing on Discovery Channel one time that it does exist but no one really sinks in it. It isn't all it's made up to be. Just think, mucky sand.

Answer 8

Yes. There is some in florida, and by the colorado river.

If you ever watch Man vs Wild (On the discovery channel) he shows you how to get out of it.

Answer 9

Yes, anywhere that ground water seeps to the surface of ground through a deposit of sand.

Answer 10

yeah it does...im not sure where it exists but i saw it in an Ep of "Man Vs Wild" when i got bored a few days ago he used a stick to pull himself slowly out