Integra... brake paddle stink to floor..?

Question

Please, Please help.. I bleeded the brake one side, each starting from drive, then back driver , then back passenager then to passenager front.. still dose the same... during the bleeding set up,, i had some one step on the padle to the floor, then release it after i tightn it.... i beleave 100% were you good, as told... i cant figure out why ? it work fine for 20 min then,, back to the stinking again,, do you know?

Answer 1

Why did you bleed them to begin with, if it was doing it before you bled them it is more then likely your break booster, but any ways to bleed your breaks with no problem's you need to take a hose that will fit around the valve. You put the hose on and you take a clear container that you can use to pour brake fluid in to. Stick the hose into the clear container all the way to the bottom, or enough to cover the opening of the hole then take a wrench not a ratchet the hose has to stay on, and you loosen the nut then have someone pump your brake's and tell them to keep pumping til you dont see any bubbles and tighten the nut back while he is pumping it. Make sure on the last pump he goes kind of slow to ensure no air gets in while your tightening it, and repeat on the rest make sure you keep brake fluid in the resovoir while it's being pumped or you will have to start over again GOOD LUCK MAN. get ahold of me if you have anymore ?'s

Answer 2

All other potential problems aside, I'd say you had the right method but the wrong direction.

drivers rear - passenger rear - passenger front -drivers front

Answer 3

bad master cylinder most likely. Or you have a leak in either one of the calipers or wheel cylinders.

Answer 4

What is stinking, other than your spelling? Use spell check, for crying out loud.