how do you set the cruise control on a 92 honda accord lx?

Answer 1

You need to set the master switch on the left side of the instrument panel to ON then use the control on the steering wheel to set the speed. Here's what the owners manual says to do:

To Set the Cruise Control:
Push the CRUISE CONTROL master
switch on the dash; the indicator
light will come on.
Accelerate to the desired speed,
then push and release the SET
switch on the steering wheel. The
Cruise Control light on the instrument
panel will come on.
The speed you were going when
you released the SET switch is the speed the Cruise Control will
hold. You can then "fine-tune" the set speed by briefly holding and
releasing the SET switch to decrease it a few mph or pushing the
RESUME switch to slightly increase it.
To Cancel the Cruise Control:
Simply push the CRUISE CONTROL
master switch and the indicator
light will go off (this also erases the
memory of the set speed).
If you must temporarily disengage
the system (but you wish to retain
the memory of the set speed): tap
the brake pedal, or the clutch pedal
(5 speed transmission) or move the automatic transmission shift
lever to N (Neutral). If you are still going above 25 mph (40 km/h),
you can return to the set speed by simply pushing the RESUME
switch. If the car has decelerated below approximately 25 mph (40
km/h), you can return to the set speed by using the accelerator
conventionally until the speed is above 25 mph (40 km/h) and then
pushing the RESUME switch

Answer 2

it may be a fuse or loose cable indoors the wiring of the cruise controller...the suitable element to do is pass to the broking service to examine it out, even nonetheless it may be in actuality a sprint pricier even if it particularly is properly worth on the suitable. much less situation and funds spend on the suitable...

Answer 3

Look in your owner's manual for where the controls are. If you can't find them, then your car doesn't have cruise control.