I think it it underneath the glove compartment..thx
2007-07-10 02:51:49 · 4 answers · asked by Anonymous in Cars & Transportation ➔ Car Makes ➔ Chevrolet
Your blower resistor is going to be attached to where ever your blower motor is.
2007-07-10 04:44:16 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Just remove the under dash panel on the passsenger side. If you have swivel sockets you can now slip this in at the back of the blower and get the screws out. Then the resistor board just slips out and then reverse this. If it is difficult, remove the blower motor for some more room and then you can see the board instead of feeling around for it behind it. Good luck.
2007-07-10 14:24:12 · answer #2 · answered by Deano 7 · 0⤊ 0⤋
Remove the close-out panel underneath your glovebox. The blower motor resistor should be right there plugged into your blower motor (It is about the size of a card & should be green). It's not a bad job.
2007-07-10 13:13:52 · answer #3 · answered by chevygirl440 3 · 0⤊ 0⤋
Check w/ the gang over @ v6z24.com and you can find out alot more than just about the blower resister on the cav;)
Good luck!
2007-07-10 10:18:49 · answer #4 · answered by Don B 5 · 0⤊ 0⤋