I tried using the switch in the hole by the license plate up and down but it wont budge. what else can I do to get it out? Thanks...
2007-07-06 16:39:34 · 4 answers · asked by Edward G 1 in Cars & Transportation ➔ Car Makes ➔ Chevrolet
If the tire has bever been down and there's a lot of rust, good luck. I had to cut mine down with a cutting wheel, You can try spraying WD40 down the hole where the crank is and let it set for a day or so. Let me know what happens
Sincerely yours,
Fred M. Hunter
fmhguitars@yahoo.com
2007-07-06 17:00:18 · answer #1 · answered by Anonymous · 0⤊ 1⤋
Switch? usually on a blazer you use the lug nut wrench that came with the truck stick the pointed end into the hole and crack the tire down. if its been up there a while pull down on the tire wile cranking it and here is a novel idea read the owners manual.
2007-07-06 23:50:45 · answer #2 · answered by JC N 3 · 1⤊ 0⤋
Try cranking it. Get your jack out and see if it has an end that fits the hole. The spare should have a cable on it, and it will lower.
2007-07-06 23:46:51 · answer #3 · answered by Bruce J 4 · 1⤊ 0⤋
Use the spair tire tool in the truck.Install in the hole in rear bumper.Turn the shaft counter clockwise till the spair tire is on the ground.
2007-07-07 00:26:05 · answer #4 · answered by HyperGforce 7 · 0⤊ 0⤋