2007-07-04 12:06:40 · 5 answers · asked by greenman 1 in Cars & Transportation ➔ Motorcycles
The battery is dead. Change it.
2007-07-04 12:17:06 · answer #1 · answered by VINGADOR 4 · 0⤊ 0⤋
I very own a save and could attempt that can assist you you. turn on the ignition swap, try for capability on the starter, and on the coil. There could desire to be capability at the two places. once you leap around the large cord to the little cord you're bypassing the commencing up facet of the swap. If it starts off there, then once you eliminate the jumper (screw motive force) from it, it stalls. this implies you're loosing the 12 volt grant to the run facet of the swap. One cord is to activate the solonoid, and the different is to maintain it working while the capability falls off. Do you have those wires crossed? the single to the interior (closest to the motor) could desire to have capability "basically" once you turn the substantial to the commencing up mode. the different could desire to have capability on it all the time, while the swap is interior the on place. If those are crossed it truly is going to act in basic terms as yours is doing. in case you haven't any longer have been given capability to the coil with the activate, then there's a difficulty with a fuse someplace between the swap and the coil, or a bad independent secure practices swap, or a bad cord. The + cable involves the starter, and yet another cord is hooked interior a similar place that components the ignition swap. turn on the swap, and it components the coil. turn it to start, and it components capability to the cord closest to the engine on the solonoid to crank the engine. discover the single that doesn't have capability while it could, and hint it decrease back to the swap. you may desire to discover the undertaking by ability of doing this. happy that can assist you you, stable success!!!
2016-10-19 02:15:24 · answer #2 · answered by ? 4 · 0⤊ 0⤋
Dead battery
Main fuse
Loose battery connections
Defective ignition switch
Unplugged ignition switch
Corroded ignition switch connector
2007-07-04 12:36:51 · answer #3 · answered by guardrailjim 7 · 0⤊ 0⤋
all answers so far hit the nail on the head try another battery ,have you tried bump starting it with the ignition on
2007-07-05 00:50:11 · answer #4 · answered by iancross07@btinternet.com 3 · 0⤊ 0⤋
dead battery.
if there were any power in the battery, then the light would come on first.
get a Voltmeter!!
2007-07-04 12:16:38 · answer #5 · answered by mdcbert 6 · 0⤊ 0⤋