Please it gives me headaches!
2007-07-03 01:51:54 · 7 answers · asked by Anonymous in Computers & Internet ➔ Hardware ➔ Monitors
Yep another common problem
1. Go to your display properties and go to advanced display settings
2. change the refresh rate of your screen eg (75hertz)
3. check you cables are fixed in properly
4. Try help or website information if further probs exist
I'm an admin so just contact me i'll help u
2007-07-03 01:56:56 · answer #1 · answered by Anonymous · 0⤊ 1⤋
LCDs do not flicker because of their refresh rate. All the people suggesting that you change the refresh rate to 75Hz are wrong and should be ashamed of themselves.
First, make sure that the system resolution on the system matches the native resolution of the panel. This is normally the highest resolution that can be selected.
Next make sure that the refresh rate is set to 60 Hz. This is where the circuits of a LCD are optimized.
Open up Notepad or a word processor and fill the screen with Hs. Then hit the Auto Setup button on the monitor. This helps the monitor sample the analog signal at the rignt time and will stop any slight jitter.
Make sure that all your connectors are plugged in properly and screwed down.
It is possible for LCDs to flicker. However this is to do with the LCD drive circuitry and not the refresh rate. If your LCD is still flickering then you need to have it serviced.
If it is flickering like a broken florescent lamp, then that could be the backlight going. Again, it needs to be serviced.
2007-07-03 09:27:25 · answer #2 · answered by Simon T 7 · 0⤊ 0⤋
Hi.
Of course, flickering LCD gives a headache, who doesn't. Either the problem is software or hardware. If it's s/w, change the setting of your monitor thru properties/settings/monitor/75hertz, and if it's h/w press the default setting button of the LCD or loose cables (please check). Your LCD is shivering coz you accidentally drop water on it. Good luck
2007-07-03 09:03:21 · answer #3 · answered by dangrmind 1 · 0⤊ 1⤋
Turn the air conditioning up?
Seriously, it sounds like you should check all the connections - the back of the monitor, computer, power connection.
If everything checks out and is tight - try another monitor - then you can tell if it is the computer or the monitor.
2007-07-03 08:58:41 · answer #4 · answered by sosguy 7 · 1⤊ 0⤋
Your ''back light'' may need to be replaced. Before you do that there is a chance you are supplying the wrong voltage to the unit. With a multimeter check your incoming house voltage (at the wall outlet). Also check the voltage your tranformer (adapter) is putting out. The output voltage on your adapter should should be clearly marked on the unit. Your output voltage may not match exactly but it should be close (within 5%).
2007-07-03 09:00:01 · answer #5 · answered by Anonymous · 0⤊ 1⤋
Jus change ur LCD or get it serviced if its freely done as a warranty
2007-07-03 08:56:35 · answer #6 · answered by Anonymous · 0⤊ 0⤋
You have power problem. Check for the UPS Battery, if it is laptop than battery. If you have the option degauge the monitor.
2007-07-03 08:58:30 · answer #7 · answered by Anonymous · 0⤊ 1⤋