heys guys thanks for replying: i have replaced evrething to its original state (inc RAM, graphics card etc etc) ive basicly as I said took fan and heat sync out and so on and tired all your answers and still nothing happens. also my moniter says "No Signal" all wires and PCI's have been re inserted and still nothin
2007-06-24 00:31:06 · 7 answers · asked by Anonymous in Computers & Internet ➔ Hardware ➔ Other - Hardware
is there any beeping, called a post beep. if there is a hardware issue you will get a pattern of beeps that repeats itself. this can help troubleshoot your issue.
you did power down and unplug the power supply before you removed any parts.....right?
did you discharge all static electricity in yourself before you touched anything? it may be a possibility that the cpu or motherboard got damaged during your upgrade.
check the monitor connector for any bent or missing pins.
have the power supply tested to eliminate that possibility.
2007-06-24 00:40:49 · answer #1 · answered by medic391 6 · 1⤊ 0⤋
if pc i coming on and no beeps to be heard you may of damaged the processor.
when taking of fan and heat sync 1st time did you check to see if it was cool if not may have dislodged chip.
if everything is replaced properly back to original state you have obviously disrupted something and my guess is you.ve put static through your processer thus frying it.
also when replacing fan and h/s have you renewed the h/s properly.
have you taken processor out at all(if you have is it replaced properly IE: no pins slightly bend).
when starting pc up can you hear the hard drive starting up and sound like it is working, or does it just start working and then stop as if it is not working you can tell the difference (if so processor is faulty)
if still got problems then get back.
2007-06-26 09:24:35 · answer #2 · answered by welshnproud 3 · 0⤊ 0⤋
you pick a static wrist strap i'm a working laptop or laptop engineer once you ability your equipment up their might desire to be a million beep accompanied by utilizing 2 beeps inspite of the undeniable fact that not all mom boards have the speaker on board so not listening to the submit beeps is a probelm does the equipment initiate ok as properly that ? If not e mail me for extra help....
2016-09-28 09:24:29 · answer #3 · answered by ? 4 · 0⤊ 0⤋
Make sure that you have the monitor set for analogue or digital signal, depending on your graphics card and connecting cable.
2007-06-24 00:51:05 · answer #4 · answered by jayktee96 7 · 0⤊ 1⤋
"No Signal" means that your monitor isn't getting a signal from your video card. Make sure that your Video Card is correctly seated and that the video cable is firmly attached at both ends.
2007-06-24 00:34:00 · answer #5 · answered by Anonymous · 0⤊ 2⤋
i think you may have damadged your ram can you not borrow some from a friend and try that.
2007-06-24 00:44:05 · answer #6 · answered by Anonymous · 0⤊ 1⤋
thats a doozy
try :
2007-06-24 02:27:45 · answer #7 · answered by Anonymous · 0⤊ 0⤋