ok my coil wont fire everyone keeps saying trace the wires all the wires are gone?

Question

i need to know how to rewire it to make it fire the only wire that is still there is the one that runs to the distributor cap all the other wires are gone is it sopose to wire to the key please help

it is a gm in line 6 cylinder engine

Answer 1

+ wire is power wire the other small wire from the coil go's into the distributor (the metal part not the cap) the big wire to the cap.. sometimes the power wire comes from a resistor that reduces the voltage

Answer 2

The GM 250 i6 is a very simplistic engine.
To wire to ignition:

1. Switch on the ignition & find the + out wire
2. Run a wire to the positive side of the coil.
3. The negative side goes to the distributor.
4. The starter solenoid has two large terminal & two small terminals. The small inside [closest to the block] is the start wire. On the opposite post place another wire & also route it to the positive side of the coil. This provides power to the coil when the engine is cranking.

Good luck
+ + +

Answer 3

to the + terminal of the coil, run a wire that sends 12v. when the ignition switch is turned on.

Answer 4

Go to library. Find basic book on automotive repair. Follow directions.

Answer 5

find direction from a technitian