when you make a bong do you have the pipe into the water?

Answer 1

Theres a lot of different ways.Im not sure about the pipe in water thing so...

I'll give you one without a pipe. And that will have you absolutely wasted in 1 minute.Trust me.

This is the easiest one to make and most practical for using what you already have in the kitchen.

Ingredients:

a litre or 2 litre bottle(33oz),
Tinfoil
A pin or ear ring.
A lighter.
Weed.

And your ready to go,


put a small hole in the bottom of the bottle(using your lighter)
You should be able to cover the whole with your thumb.

Put the tinfoil over the entrance of the top of the bottle, and make little holes, like a guaze so the weed can burn threw it.

Then Fill the bottle up almost full(obviously keeping your thumb over the small hole) Then put the tinfoil backover it, throw the weed in and start burning.

Once the weed starts to burn a bit, let go of the thumb hole and let the water pour. It will drag the smoke down with it as it pours.

Don't over burn the weed and you should probably stop burning when the water is half way down the bottle.

When the water is about 2 inches above the thumb hole, put your thumb back on it, take off the tinfoil. Suck the weed in as you let go of the thumbhole.

You might need a person to help the first few times you do it. Good luck

Answer 2

The tube from the bowl of the pipe goes into the water. When you suck on the pipe, you pull the smoke from the pipe bowl through the water (cooling the smoke) and into your lungs. It's fun trying to make a bong from whatever you have on hand...tin foil and duct tape is always handy!

Answer 3

Do you know that a bong, due to the way it's used, allows five times more chemicals into the lungs and creates more ways for carcinogens to enter. It's five times more harmful then cigarettes.

Answer 4

no

the bowl goes in the water..

the breathing tool does not.

Answer 5

look here :http://www.cannabisculture.com/cgi/ubbthreads/printthread.php?Cat=&Board=bong&main=252481&type=thread