2007-06-11 07:29:13 · 6 answers · asked by fordrider1 1 in Cars & Transportation ➔ Car Makes ➔ Chevrolet
distibutor cap. should be in the center behind your motor
2007-06-11 07:34:07 · answer #1 · answered by ? 3 · 0⤊ 0⤋
If this is an engine with the new style distributor the coil wire goes to the rear-most position on the passenger side.
2007-06-11 16:20:16 · answer #2 · answered by Ron B 6 · 0⤊ 1⤋
It atttaches to the distributor. It will be the one in the middle of the dist. cap on most motors, but on some of the optisparks it is the top one on the drivers side. Good luck.
2007-06-11 14:36:06 · answer #3 · answered by Deano 7 · 0⤊ 1⤋
there are at least 2......the smaller one is your primary feed ...it attaches to a 12 volt supply wire controlled by the ignition switch...this wire is to supply power to your coil...then grounded by either your module or ignition point,s ..however equipped....the larger is your secondary power wire...it go,s to the center terminal on your distributor cap.....unless you have multicoil ignition....then it go,s to the corresponding spark plug.....hope this help,s....good luck!
2007-06-12 00:15:53 · answer #4 · answered by slipstream 7 · 0⤊ 1⤋
it goes from the coil to the center of the distributer cap.
2007-06-11 14:34:17 · answer #5 · answered by Ricky H 4 · 0⤊ 1⤋
To the center of the distributor.
2007-06-11 14:32:39 · answer #6 · answered by Chief 4 · 0⤊ 1⤋