2007-06-10 03:11:30 · 11 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
The brake calipers act the same way. Pad change should be done on rotors above minium thickness that have been refurfaced so the new pad works wears in properly. It is bleeding the abs system that gets owners in trouble.
2007-06-10 03:18:20 · answer #1 · answered by John Paul 7 · 1⤊ 0⤋
Yes, ABS is nothing to worry about when changing your brake pads. Be sure to pick up a manual for your particular car to use as a reference before you get started. These manuals can be found at your local auto parts store or purchased online. They provide step by step instructions tailored to your particular car. They will also tell you about any special tools you may need to complete the job. Good luck.
2007-06-10 03:22:48 · answer #2 · answered by cmfeuers 2 · 0⤊ 0⤋
the ABS is a computer controlled safety devise which "pulses" the brakes when a skid is sensed by the computer. this has no effect on how the brake pads are installed. If your confident with your mechanical ability in this repair just follow some manual or advise of a mechanic and you should have no problem..
2007-06-10 03:20:45 · answer #3 · answered by billjac 2 · 0⤊ 0⤋
yes ,you sure can.the abs system has a sensor on the wheels,and touches the stater plates on the hubs,do a brake job like always and make sure the sensors are touching the plates when you're done.the abs system will not ever cause your brakes to fail. a standard procedure is all it takes to replace the shoes and pads..
2007-06-10 03:20:00 · answer #4 · answered by jcr 3 · 0⤊ 0⤋
relies upon on what type of motor vehicle we are conversing approximately. Early motor vehicle applications of ABS might have a reserve stress. that's the ABS accumulator. Such accumulators are designed to hold a intense PSi interior the equipment. crimson flag's up right here. persist with all warnings and innovations by making use of the motor vehicle producer. exceptionally whilst appearing brake paintings. ultimate desires and stay risk-free.
2016-10-07 05:38:38 · answer #5 · answered by ? 4 · 0⤊ 0⤋
yes, but when you push the piston(s) in the caliper back in, be sure to crack open the bleeder screw to prevent pushing dirt and other contaminants back up through the abs... which could cause it to malfunction and could also cause you to flip the seal in the master cylinder resovior which could cause a leak. it will leak a little bit of fluid, but it helps to protect your ABS, and after you get the piston all the way back be sure to tighten up the bleeder screw again! or else you could get air in the lines and result in a spongy brake pedal causing you to have to bleed your brakes
2007-06-10 07:52:35 · answer #6 · answered by some guy 2 · 0⤊ 0⤋
yes it is no differnet than any other brakes except there is a sensor attatched to the wheel hub. It plays no roll in changing the brakes
2007-06-10 18:08:33 · answer #7 · answered by rwings8215 5 · 0⤊ 0⤋
yes the abs is just a computer ..
2007-06-10 03:16:34 · answer #8 · answered by Anonymous · 0⤊ 0⤋
sure! no different than non abs
2007-06-10 03:21:32 · answer #9 · answered by bob D 3 · 0⤊ 0⤋
yes
2007-06-10 03:14:50 · answer #10 · answered by Anonymous · 0⤊ 0⤋