2007-06-10 02:24:26 · 4 answers · asked by Elizabeth 6 in Home & Garden ➔ Do It Yourself (DIY)
is like a clear gel coat they put on top of fiberglass or other painted stuff to seal it.ya sand down the original coat then put on the new stuff.
2007-06-10 02:33:39 · answer #1 · answered by dewme_nomad 1 · 0⤊ 0⤋
I agree with Steven Wolf. The experiences that I've encountered with resurfacing are not favorable. You can never replace the hardness and durability of a factory porcelained enamel finish on steel tubs and the factory gelcoats of fiberglass tubs, period.
"Resurfacing" is just a fancy word for painting. The finish is somewhat like aftermarket automotive painting and often does not last for more than a few years. Many of these companies offer a one or two year warranty, but what is that worth if you have to have them back once or twice...
There are, however, companies that offer around ten year warranties. They may have a decent product. If you do decide to "resurface" get some referrals and use your good judgement!
In my opinion, the only time that I would resurface is to give the bathroom a clean look in order to sell.
Good luck and I hope this helps.
2007-06-10 03:36:43 · answer #2 · answered by mpruvn 2 · 0⤊ 0⤋
"Re-surfacing" a largely disappointing procedure is usually attempted on enamel/ceramic glazed tubs. Certainly it "CAN" be done, but I wouldn't take a job that asked for it.
With a fiberglass tub it may be a bit easier, but have the same end result.
I once worked strictly in laying up fiberglass for molds etc, and Fiberglass resin will not strictly dry clear. It could be poured and spread in a tub, but also will be subject to gravity and pooling, in the tub.
Professionally it could be accomplished much like "laying" up a boat hull, with resin and any color "gelcoat", but that would likely mean removing the tub.
If you have issues with staining, or cracking, or just want a fresh new look, you might be as well off buying a new tub and instaling it or have it installed. The effort you expend in a RE-DO might be as costly, and at some point less than a joyful experience.
Steven Wolf
2007-06-10 02:47:13 · answer #3 · answered by DIY Doc 7 · 1⤊ 1⤋
fiberglass can be resurfaced. preperation is different than porcelin.remove all original finish by sanding. make sure to change paper often because of soap scum. make any repairs w/ fiber resin, sand smooth w/100 grit paper. the new coating shoud be an epoxy primer w/ a urethane finish. home d.i.y kits are,nt very reliable. hire pros for around 200.00
2007-06-10 02:58:15 · answer #4 · answered by Anonymous · 0⤊ 0⤋