I removed the Driver side Transaxle (CV) shaft, I replaced it with a new one, however i can't seem to get it to seat all the way into the transmission, I pulled it back out and looked inside the transaxle and their appears to be a Horrizontal shaft that will not allow the splined end of the axle go into the transalxe all the way. Does this shaft have to been slide up or down ?
it dosent seem to what to move
2007-06-06 14:08:52 · 3 answers · asked by bigboy 1 in Cars & Transportation ➔ Maintenance & Repairs
lay the two shafts side by side, and compare them for lenth, diameter, or any other variations.some times you have to give the shaft a tap with a small hammer and block of wood. that shaft that you are seeing ill bet is the differential side gear support.it will not move.
2007-06-06 15:55:22 · answer #1 · answered by mdk68gto, ase certified m tech 7 · 0⤊ 0⤋
Compare it with the old one and make sure it is the correct one...if it is line her up and give it a good shove in
2007-06-06 22:07:21 · answer #2 · answered by simonj_smith 4 · 0⤊ 0⤋
it pops in there just a good shove
2007-06-06 21:15:01 · answer #3 · answered by Anonymous · 0⤊ 0⤋