After primming and spraying starting fluid in its appropiate places whats else could possibly be wrong and how can you tell if the fuel pump has went out?
2007-06-03 15:00:39 · 5 answers · asked by Anonymous in Cars & Transportation ➔ Other - Cars & Transportation
ALL the air needs to be bled out of the ENTIRE fuel system all the way to the injectors.
Don't ruin your starter by continualy cranking the engine!!
Fuel pumps will NOT pump air.
ADDED:
You may get luck by disconnecting ALL the fuel lines at the injectors and cranking the engine for 30 seconds.
Wait two minutes, and crank it again for 30 seconds.
It's going to make a mess with diesel squirting all over the engine, but short of doing that, there's nothing else YOU can do without calling a pro.
I hope you prefilled the fuel filter???
2007-06-03 15:12:26 · answer #1 · answered by Mr. KnowItAll 7 · 0⤊ 0⤋
The diesel engine is a lot harder to start after,running out of fuel.The first thing is to fill the fuel filter with fuel, you may half to do it a couple of times,put the filter on and try starting,it will skip and cough. Be certain the air filter stays on.The object is to get the air out of the lines,once it passes and the injectors have all fuel,the engine will smooth out.
2007-06-03 15:21:05 · answer #2 · answered by PaulyM 3 · 0⤊ 0⤋
on the gasoline clear out there's a priming pump ( appears like a chief ball on a backyard mower with a rod related to it. on the area of the housing for the clear out is a 10mm bolt loosen that bolt and top the device then initiate with finished throttle until commencing. Watch the exaust or get help if smoking white then your getting gasoline, and this is going to start up off sluggish throttle and save cranking. you additionally can would desire to crank it swifter ( Use a Battery charger to help there.) stable good fortune. do no longer use starter fluid this could injury a deisel motor previous restoration. this is the stairs to bleed injectors.
2016-10-09 09:58:55 · answer #3 · answered by ? 4 · 0⤊ 0⤋
If it only ran out of fuel and you had no other ongoing problems , then it needs to be primed correctly.
Loosen one of the injector bolts preferably the one furthest from the supply hose and prime with pump 'till fuel comes out of injector!! Then you may need to wind it over a few times to fire. This will also check your fuel pump to see if any fuel is getting to your injectors.
Good luck!!
2007-06-03 15:15:55 · answer #4 · answered by squid 1 · 0⤊ 0⤋
Hell,you can't even spell Detroit or diesel.
They all fell for it.LOL
2007-06-03 15:12:01 · answer #5 · answered by gdwrnch40 6 · 0⤊ 0⤋