The pump is on the plastic container that holds the fluid its on that plastic thing
2007-06-02 13:51:21 · 5 answers · asked by Merle 1 in Cars & Transportation ➔ Maintenance & Repairs
simple as pull the old one out and push the new one in.
2007-06-02 15:15:47 · answer #1 · answered by Ron B 6 · 0⤊ 0⤋
Assuming this is an exact replacement for the existing pump, it should be a matter of removing the old pump and putting the new one on.
Usually, the pump "plugs" into a rubber bushing or grommet in the side of the reservoir, with the body of the pump snapping into a clip or a retainer that's molded into the reservoir.
You may need to remove the reservoir from the car to access the pump.
2007-06-02 20:58:54 · answer #2 · answered by HyperDog 7 · 0⤊ 0⤋
To make it simple, there should be an in and an
and out on the pump. Try it .Not right? Switch it.
2007-06-02 21:04:17 · answer #3 · answered by Anonymous · 0⤊ 0⤋
if you know where it is then you know about how to take it off the thing is getting one to replace it that you should be able to see bolts or screws holding it on and feel for them
2007-06-02 20:59:48 · answer #4 · answered by infoman89032 6 · 0⤊ 0⤋
Just PULL it out, and stick the new one in.
It's held in by a rubber gromet.
JUST PULL......
2007-06-02 20:59:53 · answer #5 · answered by Mr. KnowItAll 7 · 0⤊ 0⤋