English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

I'm going to be replacing my fuel pump for my 99 integra GS-R...I was going thru the service manual and from what I understand, the fuel pump is underneath the rear seat...Is that correct??

2007-06-02 04:14:11 · 4 answers · asked by sinamotamedi34 2 in Cars & Transportation Car Makes Acura

4 answers

Yes just go about the job with a fire extinguisher and less than 1/4 tank of fuel if possable do it out side don't want to burn down the house. Pull the fuel pump fuse start the car to bleed off any remaining fuel pressure when it dies there will still be fuel squirt when the fuel line is removed. Ingintion key off and might disconnect the battery too. take out the seat bottom look for a cover with wires running thru it. some times you may need to take the seat back out too. Be carefull the fuel tank has very sharp edges wheather it is plastic or metal. Get a complete pump assembly with a fuel tank sending unit built on from Honda or Acura also check in the box for the sending unit o ring. Some pumps have them some don't.

2007-06-02 04:24:28 · answer #1 · answered by John Paul 7 · 0 0

Its actually quite simple. My 99 civic EX has the same location. I had to swap my fuel pump when I did my engine swap and turbo kit. Just push in on the front of your rear seat, lift up, you will see a panel with 10mm bolts, loosen them the fuel pump is underneath, loosen the 8 (i think) bolts after disconnecting the fuel lines and electrical connector, lift out at an angle, pull the fuel pump from it's housing, take off the filter, replace filter and fuel pump install in the reverse, and you are done. It takes about 15 minutes.

2007-06-02 11:16:42 · answer #2 · answered by hondab16tuner 6 · 0 0

you're able to try this your self regardless what individuals say.The pump is interior the tank.confirm lots of the gas is bumped off earlier attempting to change it.This tank is awkward and somewhat heavy yet you're able to do it with the help of your self in case you have a million or 2 floor jacks.I somewhat have executed it many situations with the help of myself!!There are purely 2 straps preserving the tank up.earlier removing the straps confirm you're taking the gas lines off the gas filter out.Even those lines may well be a discomfort because of the fact they have 2 little gay plastic clips preserving them directly to the filter out and on occasion they are able to be a headache.it is likewise possible to destroy one.confirm you gas lines are depressurized!!you will additionally could open the gas door and relax the bolts that carry the neck to the rear quarter panel.The filler neck merely slides into the tank.you are able to lube the neck with some mild oil to help whilst reinstalling.There somewhat isnt lots to it upon getting the hoses off the gas filter out.merely drop the tank and deploy the recent pump.merely confirm you get a clean rubber ring for the desirable suited of the gas tank the place your pump slides into.additionally positioned a mild coating of grease in this seal too whilst reinstalling,this might help it seal up.I cant aid you comprehend what style of techniques you like because of the fact on occasion regardless in case you have the desirable suited how you're able to do it,it takes the incorrect gadget to grant you somewhat help additionally.as long as you have a sturdy socket set,some screwdrivers and a couple of floor jacks,you would be nice.might as nicely throw a hammer in there too.They constantly are available useful for something yet probable no longer in this job.sturdy luck!!

2016-12-30 14:07:42 · answer #3 · answered by okon 3 · 0 0

AZ

2007-06-05 14:29:32 · answer #4 · answered by Maz 2 · 0 0

fedest.com, questions and answers