I have a dell optiplex gx 240 motherboard with a 1.5 cpu and a optiplex gx 260 motherboard with a 2.4 cpu. Can I take the bigger cpu and switch out the older smaller cpu without any problems?
2007-05-31 11:50:54 · 8 answers · asked by fatman92 1 in Computers & Internet ➔ Hardware ➔ Desktops
I think you need to change the motherboard in your computer to get a higher CPU.
A motherboard that fits you cant at Dell.
2007-05-31 11:55:09 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Yes the GX260 processor (P-4 socket 478, 2.4Ghz, 533fsb) will physically fit. The motherboard will even automatically recognise it. A GX240 & GX260 are almost identical. A GX240 uses a P-4 socket 478, 1.5Ghz, 533fsb processor. You should even be able to use the heatsink and fan from the GX260 in it. Actually, there were several different speeds available on the GX240 boards from Dell. From the lowest 1.5Ghz, to the 2.6Ghz They all use the same motherboard, but just came with a different cpu.
When removing the processor, keep in mind the following:
1: Remove the green clips, then gently release one side of the heatsink from the tab holding it. There is one in the center of each side where the clips were.
2: The processor will be stuck to the bottom of the heatsink, don't twist or bend the heatsink when you are removing it or you'll damage the pins.
3: use a butter knife to gently pry the processor from the heatsink. It will usualy pop loose pretty easily.
4: Do not touch the pins! They are very easily bent.
5: Release the locking lever and gently insert the processor into the holder on the board. It will only fit one way, and should drop in with zero force. Do not push it in, or you'll bend the pins.
6: lock the processor in place by placing the lever in the down position.
7: Use an alcohol wipe, and clean off all the old heatsink compound from the heatsink and the processor.
8: Apply a small dab (About the size of a Tylenol Gelcap) of Silicone Heatsink compound (Available at Radio Shack or computer stores) to the center of the processor back.
9: re-install the heatsink, and make sure that it fully seats in the holder. It should click into place with a little pressure.
10: Reinstall the fan, and make double sure it is plugged into the motherboard.
12: At boot, press F2 several times until you see "Entering Setup mode"
13: In setup, verify the processor speed detected, and the close. Saving any changes and reboot.
14: Enjoy!
2007-05-31 12:25:43 · answer #2 · answered by Anonymous · 1⤊ 0⤋
there's a distinction between the processor and the working equipment. Dells are set as much as run domicile windows; it is the language they understand. The Macs that use Intel CPU's will nevertheless be set as much as run OS X. only having the comparable form of processor isn't adequate.
2016-10-09 05:25:10 · answer #3 · answered by ? 4 · 0⤊ 0⤋
That is easier done w/ retail motherboards because they usually support a wide range of processor models and speed. Proprietary motherboards tend to limit your upgrade options because the OEMs really prefer that you buy a new one rather than upgrade.
But you could give it a try and tell us later how your luck played out.
2007-05-31 12:16:09 · answer #4 · answered by Karz 7 · 0⤊ 0⤋
the problem is Dell won't leave you much room for upgrade to try and force you to buy from them again, oh and if you wan't to change your motherboard, erm well if you buy one, it won't fit in your dell case, that is on purpose to make it hard to upgrade so that they can try and squeeze you but all the big companies are the same really, what your best off doing is saying **** to dell and get a computer from a small business they are often reasonalbe and they also use all standard parts so you are more free to upgrade.
2007-05-31 12:00:20 · answer #5 · answered by Anonymous · 0⤊ 2⤋
Personally, I hate Dell. And I would suggest building your own computer. You could build a fast new one for about $565.00 if you get the parts from http://www.tigerdirect.com But if you don't need a new monitor, it would be $415.00
2007-05-31 13:25:27 · answer #6 · answered by duron1_2 4 · 0⤊ 1⤋
typically the "big companies" want you to purchase a new PC ... to answer your question it is possible that it will work...but not likely. they limit upgrade to the next speed for the most part
2007-05-31 11:55:39 · answer #7 · answered by PBcompanies.com 4 · 1⤊ 0⤋
no, differnet motherboard. the older one cant handle the new speed. it will only say 1.5 no matter what.
2007-05-31 11:54:41 · answer #8 · answered by sivart7555 5 · 1⤊ 0⤋