use alot of canned air
2007-05-31 11:15:34
·
answer #1
·
answered by Anonymous
·
0⤊
0⤋
You can take a flat-head screw driver or something else flat and hard to snap off all of the keys, and clean them individually. When taking the keys off do not turn the screwdriver sideways so that the key will lift up sideways, this will leave marks on the keyboard.
For instance the way you would want to do it is insert the screwdriver under the top of the #1 key so the handle is facing towards the monitor (if thats what you have your keyboard infront of) then push down on the handle and the key will pop right off.
2007-05-31 11:15:55
·
answer #2
·
answered by DeadStylezX 1
·
0⤊
0⤋
you are so gross!The reason for it being sticky is your business.Try to use a very thin wet cloth like a babies wipe or a wet paper towel and use a hair pin or a very thin hard object like a butter knife to go through the keys(do not pop the keys,this will help with out doing it.)Go behind the keys several times until you see the cloth clean.This helped me when my son waist soda on the keys.If I was your family I wouldn't touch that keyboard.Maybe you need to wet the paper towel with alcohol instead of water.
2007-05-31 11:09:55
·
answer #3
·
answered by qtpie34 2
·
0⤊
0⤋
Sorry, various keyboards in little while won't be achievable :( a minimum of no longer in case you desire to scrub them nicely. formulation 409 and Q-information paintings nicely, even even though it truly is a tedious job. do no longer spray the keyboard... dip the Q-tip in some 409 or comparable cleanser and sparkling away. you need to use a mild rag dipped in the cleansing answer for the "bezel" area and the tops of the keys.
2016-10-09 05:21:01
·
answer #4
·
answered by Anonymous
·
0⤊
0⤋
you can take the keys out of the keyboard and clean up underneath... just remember where the keys go so you don't have a weird combination on the board
P.S. have a towel close by ext time
2007-05-31 11:07:47
·
answer #5
·
answered by Fugazi sez WHAT?? 2
·
0⤊
0⤋
They don't make keyboards like they used to,the buttons don't pull off nowadays,take it apart and clean it with windex..if your serious about the mess,get a black light and see what part is messy,then smash it with a hammer.
2007-05-31 11:07:20
·
answer #6
·
answered by Poker Face 6
·
0⤊
0⤋
unplug it first, so you don't do something to your system.
next, go to an electronics store, or costco and buy canned air. Blow all the junk out from between the keys. Wipe it all down with windex.
you are set. if you want to keep it looking nice, you can just blast it with the canned air at any time.
2007-05-31 11:09:13
·
answer #7
·
answered by Anonymous
·
0⤊
0⤋
remove each key 1 row at a time place them in order as you do them on a table, then click them back on after yuo finish each row, be careful when taking key off,
good luck
2007-05-31 11:06:34
·
answer #8
·
answered by Anonymous
·
0⤊
0⤋
Put your keyboard in the shower, then let dry.
2007-05-31 11:08:13
·
answer #9
·
answered by Anonymous
·
0⤊
0⤋
go to a guitar center.
2007-05-31 11:09:02
·
answer #10
·
answered by cadaholic 7
·
0⤊
0⤋