English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

14 answers

when you use the computer, a lot of stuff such as programs and files are loaded in and out of the memory and the hard disk. this can cause error sometimes..

when you shutdown, everything get unloaded from the memory and stuck programs are closed.. most errors are resolved if you do this.

also, every time you shutdown, the system will be restored to its normal startup state.. any program that causes error would not interfere unless it is included in the startup..

use msconfig to view and change the startup.
[open run (windows key + r) then type msconfig]

2007-05-24 00:43:28 · answer #1 · answered by kish 2 · 0 0

because when u restart the computer, the system automatically shuts down any faulty program running and stops it from doing any damage to the computer, it wil tell you that there may have been a problem when you restart the computer.

2007-05-24 01:45:21 · answer #2 · answered by devil_child66662000 2 · 0 0

Many times its because a program/process encountered an error. By restarting the computer you also restart/terminate that program, thus fixing the problem.

2007-05-23 19:42:02 · answer #3 · answered by UsernameIsTaken 3 · 1 0

It totally removes from memory the problem program, then it restarts and the fault does not happen. Its to do with the very fragile nature of the electronics in the computers.~~

2007-05-23 19:43:21 · answer #4 · answered by burning brightly 7 · 1 1

because sometimes a during a load up a failed driver didn't initialize thus causing the problem. for software, loss of memory is the most inherent problem, thus restarting freeds the memory and have it ready for use by the software

goodluck!!!

2007-05-23 20:02:25 · answer #5 · answered by PeeVeeOhh 3 · 0 0

When your tired your mind doesn't function as well as it would after having a goodnights sleep.Therefore mistakes are made, your memory is all f***** up and things start to go wrong.
Well think of a computers brain working in the same way, once rebooted and refreshed, the memory is clearer and things start functioning a lot better and things get done faster.

2007-05-23 20:08:53 · answer #6 · answered by helen jt 2 · 0 1

while you're working Microsoft living house windows, that's in all possibility that one in each and every of two issues is going on: a million) living house windows is attempting to place in computerized updates. while you're working XP, there could be an option to tutor off the pc without installation them. you may get admission to this from the suggestions it exhibits you once you attempt to close down. 2) living house windows can't close down as a results of fact it could no longer close down a software which you're working (those could be computerized tactics working in the history which you will no longer relatively see, like classes that at once replace themselves.) in case you spot an blunders message approximately living house windows attempting and failing to close a undeniable software, you may close this technique off manually with the activity supervisor. (administration+alt+delete) to no longer insult your intelligence, yet are you specific you're determining on "close down" and not "restart?"

2016-11-26 22:19:31 · answer #7 · answered by ? 4 · 0 0

It pretty much boils down to bad programming which can be the cause of memory leaks, clashes or memory consumption.

2007-05-23 19:53:11 · answer #8 · answered by terence_legrange 1 · 0 0

Cos Bill Gates hasn't quite yet figured out how to make Windows work properly.

2007-05-23 19:45:52 · answer #9 · answered by Icarus 6 · 0 0

If flushes out the content of the memory and therefore the next time you boot up it acquires new values.

2007-05-24 00:50:21 · answer #10 · answered by Anonymous · 0 0

fedest.com, questions and answers