I have a SD card slot on a board. I want to wire up a USB slot on the board. maybe even remove the SD Slot and Replace it with a USB slot (Female end)?
I would prefer the USB SLOT(Female) end to be the USB-Mini.
Can anyone point me in the right direction to do this?
2007-05-20 13:46:22 · 4 answers · asked by BillyBober 1 in Computers & Internet ➔ Hardware ➔ Other - Hardware
THen how would I wire one on board?. I want to be able to write to the card from USB, and any connections that the SD Slot uses I want my USB slot to use also.
2007-05-20 13:58:13 · update #1
Ok maybe some of you dont understand. This is not for A PC by any means. I have a board with an SD cardslot that is used to play homemade roms on my Gameboy advance. I was wanting to put a USB on the board so I can put the roms on a flash drive.
2007-05-20 14:25:32 · update #2
I cannot get a bigger SD card. it only supports up to a 2gb card. something about how after 2gb its made a little differently.
2007-05-20 14:51:10 · update #3
best just get bigger sd card, flash drives need to be plugged into the pc directly not a card reader such as your gameboy hack card
2007-05-20 14:32:13 · answer #1 · answered by Anonymous · 0⤊ 0⤋
Sorry, there's no way to do that kind of swap. You can install a USB card and leave the SD reader there.
2007-05-20 20:51:03 · answer #2 · answered by CinderBlock 5 · 0⤊ 0⤋
Make life easier, just get a USB hub if you need more USB connections. You might just ruin your PC, burn a finger or inhale a lot of lead doing it.
2007-05-20 21:08:25 · answer #3 · answered by Karz 7 · 0⤊ 0⤋
http://answers.yahoo.com/search/search_result;_ylt=AtytqeLKKVSErlc93TvszDtw7hR.?p=SD+slot+to+USB+slot
2007-05-20 20:51:04 · answer #4 · answered by helpdesk916 ♦♣♠♥ 6 · 0⤊ 1⤋