How do I remove old ceramic tile and replace it around my shower?

Answer 1

http://www.johnbridge.com/vbulletin/forumdisplay.php?f=1

Answer 2

Qtn is very simple & answer is also simple.

These days Marble cutters are avaialbe to cut the Ceramic tile/s.Pl cut the tile with cutter & remove the same.You may fit the new tile with Cement.Pl ensure that the colour & pattern of of tile is same as old one.Pl engage messon for above work.
Donot remove the tile without finding replacement.

Answer 3

Ken is right. the 1st subject is that the tiles have been put in with mastic. (nicely, the 1st subject substitute into genuinely attempting to apply greenboard in a moist section). the best answer may be to eliminate the greenboard and replace it with an approved water resistant approach. whether it is cement backerboard or a kerdi equipment is as much as you and your wallet. you could study approved techniques on my internet site. the undeniable fact that that is just one portion of the bathe doing it particularly is merely a seem at issues to come again. The greenboard will ultimately all fail. Sorry, not attempting to be the bearer of undesirable information. that is greater useful to repair it now, nevertheless, earlier that is going to become a substantial subject with the framing and studs in the back of the bathe. If those swell and want replaced it will be no small affair.

Answer 4

You don't have to remove the old tiles if you don't want too. You can tile right over the old tiles. Make sure all the old tile is tight and replace any missing tiles with scrap tiles. They have trim tiles the thickness you will need.

Answer 5

Removal is relatively easy. Without knowing if you want new/different tile or not (Which one might have to assume) begin by gently removing a single piece, then using a stiff blade scraper, and possibly a hammer (Gently) wedge under the successive tiles until they pop off. If you don't care about saving, then you can be a bit more aggressive, but should consider possible damage to the substrate,,, or removal and replacement of that as well.

Steven Wolf

Answer 6

take a hammer and a chisel and knock it out ..