Can I cool with radiant floor heat?

Question

I have raidant floor heat ran by a Weil Mclain boiler, primary secondary pumping with four zones, zones ran off separate four zone controller. Is it possible to run zones without boiler and cool a slab?

Answer 1

It could probably be hooked up to run cold water through the system. As for cooling, I doubt it. Cold air drops to the floor while hot air rises. If you just want to cool the slab, it may work.

Answer 2

No you would not want to try to cool a house that way. If you even pumped cool groundwater you would have a sweating floor. Your floor would be wet just like a glass of ice water sweats on a hot humid day.

If you chilled the water moving though the floor with a refrigeration system you would have an ice skating rink. The water that would condense on the floor would freeze.

This is just asking for mold and moisture damage.

Answer 3

There are 3 forms of radiant warmth for flooring. First there is the electrical powered, additionally the water, yet there is likewise a product referred to as "AirFloor" which makes use of a multi-duct equipment that's poured into the concrete. those little community of ducts replaces the well-known duct equipment for the construction. the two way you bypass, moisture should not be a situation. while you're apprehensive relating to the resinous coating, bypass with a real polished concrete. that is going to final perpetually and is upkeep loose. as long because of the fact the construction is saved at a persevering with temperature, sweating should not be an argument. stable success

Answer 4

You would have to rewire for this but why not! If you use metal piping in the ground, say four to ten ft under ground, for the cooling it just might work. I think the average temp of the ground below 4 ft should be between 45 & 60 degrees F.

Answer 5

I agree with mike b.