My friend filled water in to the compartment where you are suppose to insert engine oil. What should i do?

Question

The engine and car still works and all, but it vibrates a lot more. Help!

Answer 1

You're going to need to take the vehicle into a shop and have them flush the system out. As you probably have heard water and oil don't mix. The water when mixed with oil causes a gummimg up process and turns milky white, it is thinning out. Oil is there for a reason (lubrication, heat dispursement, etc.)

Answer 2

Step 1. Turn off engine!! Water in the engine can cause extensive damage to your engine. Remove the oil drain plug located under the engine on the drain pan. Let the oil drain for awhile to ensure all the oil has drained out. Put new oil into engine. Don't forget the plug!!! Your vehicle should tell you the type of oil to use eg. 10w-30 or 5w-30. There is usually a sticker located under the hood with all of the specifications.

Answer 3

Don't run the engine anymore. You'll damage the engine. Have your car towed to a shop to change the oil or get a friend to come over and change your engine oil and install a new filter.

Answer 4

Overfilling you're engine can bring about unfavorable gaskets, seals, and is in basic terms in basic terms undesirable. do this: with the motor vehicle chilly, and the final time for that's interior the morning while u upward push up, pop ure hood, and view ure oil lower back. If u see rather a number of oil previous you're finished line, in basic terms in basic terms get a oil pan or in basic terms a pan that huge sufficient to seize some oil and take of you're oil plug, it somewhat is located on the backside of your oil pan. permit the rather some oil pop out(be carefull is going to be pouring out, so placed on gloves). After u see that u took out a quart or so in basic terms placed the plug lower back in, hand tghten it and bypass lower back to the genuine of ure engine compartment and take yet another examining. If u bumped off to plenty oil, in basic terms in basic terms advert some. If no longer sufficient became into bumped off, repeat technique. that's no longer even close as complicated because it sounds so do exactly it. Ull be chuffed, u did it your self.

Answer 5

this sounds like the time i put diesel in my fuel tank my husband says drain the oil completely go and by an oil engine flush add oil when you do the flush and then change the oil again and there is something called restore buy the appropriate engine size type 4 cylinder 6 cylinder etc and the restore you put in with your oil change good luck and hope all goes well with your vehicle my husbands says if you give more details he could help you more our email address is [e-mail] well good luck and i will check my emails through out the day

Answer 6

Drain the oil. Then take the pan off and wipe it out, put a new gasket on, and sealer, and reattach the pan. Make the next couple of oil changes within a short time, and do it when the engine is HOT.

Answer 7

Do not run the engine
Drain every drop of oil and water out of it that you can.
Change filter and add new oil.
Run for a few moments and repeat the above.
Run for a few more minutes and repeat the above again.
Change oil and filter again in a few hundred miles if it seems to run okay.
If it still doesn't seem to run okay after the first two oil changes,hang it up. Your buddy ruined your motor.

Answer 8

Oh my........

Be prepared to buy a new engine.

You need to have the oil changed, and flushed a couple times to get all the water out of the engine oil.

Answer 9

DO NOT RUN THE ENGINE! Doing so will cause considerable damage. Call the tow truck, tow your car to your mechanic, and tell him what happened. Now try to find a friend that is a little smarter, after you collect the cost of the repair from him or her of course.

Answer 10

Oil must be drained and flushed. Engine parts lubricated by oil, such as rings and pistons, dont like water. I don't suggest you drive the car until that is done.