2007-04-25 16:01:18 · 9 answers · asked by Anonymous in Cars & Transportation ➔ Maintenance & Repairs
if they are exhaust clamps there is three things to do. One is spray them with lube and hope they come loose. another way is to heat them with a torch and then work them off. and the last is...just turn them until they break and replace them...they are cheap ...that's what I'd do.
2007-04-25 16:10:51 · answer #1 · answered by Kenneth S 5 · 0⤊ 0⤋
If your talking about the exhaust manifolds to do a valve job just disconnect the manifold from the pip and remove it with the head, other then that , may the force be with you, bless you
my son and good luck
2007-04-26 00:14:07 · answer #2 · answered by Nancy P 5 · 0⤊ 0⤋
I normally will heat the nuts up with a torch until they are glowing dull red, then put the wrench on then and they will usaully come loose
2007-04-25 23:06:44 · answer #3 · answered by james m 2 · 0⤊ 0⤋
Did you spray some wd 40 on them to loosen them up?
2007-04-25 23:04:41 · answer #4 · answered by Lori O 3 · 0⤊ 0⤋
i would cut them with a die grinder unless they are the ones that hold the manifold 2 the block
2007-04-25 23:09:05 · answer #5 · answered by Anonymous · 0⤊ 0⤋
B'laster. It's a miracle spray.
2007-04-25 23:06:20 · answer #6 · answered by Anonymous · 0⤊ 0⤋
spray with WD-40 first. Let it sit for a little while.
2007-04-25 23:04:15 · answer #7 · answered by SumUnknown 3 · 0⤊ 1⤋
you will have to cut them off with cutting torch
2007-04-25 23:05:42 · answer #8 · answered by dom 2 · 0⤊ 0⤋
which part of the exhaust?
2007-04-25 23:04:21 · answer #9 · answered by impulse784 2 · 0⤊ 0⤋