I am removing the carb so it can be cleaned I have it all detached except for where the throttle cable goes in. how do you properly release the cable so I can remove the carb.. The carb is a little different then what I am used to.
2007-04-19 14:35:39 · 3 answers · asked by Ronald H 2 in Cars & Transportation ➔ Motorcycles
Remove the cover on the right side of the carb.
Hold the cable and lift the throttle arm.
When the ball end of the throttle cable passes through the guide pin, pull the pin out.
Do not lose the pin! It happens.
2007-04-19 16:17:38 · answer #1 · answered by guardrailjim 7 · 0⤊ 0⤋
1999 Yamaha Big Bear
2017-02-20 20:33:14 · answer #2 · answered by Anonymous · 0⤊ 0⤋
starter solenoid. very user-friendly. wager it is honestly considered one of the only areas your community Yamaha broker shares because of the fact persons are constantly changing them. you are able to attempt it by making use of leaping the two terminals on the solenoid. it might start up then as much as date: definite it might nonetheless turn over each and every so often. it is going to frequently make a "click" noise. the terrific thank you to objective it is get a chew of cord amd leap the two terminals on the solenoid. If it starts with leaping the solinoid and not with the main important then it is the solinoid. If it nonetheless does the comparable element and you had the battery examined then its the starter.
2016-12-26 15:45:37 · answer #3 · answered by ? 3 · 0⤊ 0⤋