One wiper doesnt work. Tightend up the base and it worked for a few minutes then it stopped again
2007-04-19 14:22:24 · 4 answers · asked by Cris 1 in Cars & Transportation ➔ Maintenance & Repairs
The "link rod" is probably loose or fell off. You'll have to remove the wiper arms and raise the hood...remove the plastic ventilator grille over the wiper linkage, you should find the problem from there
2007-04-19 14:28:32 · answer #1 · answered by Michael B 6 · 0⤊ 0⤋
try putting a lot of torque on the nut and if that does not do it, you may need a new wiper arm and a wiper transmission assembly.
2007-04-19 14:26:59 · answer #2 · answered by Anonymous · 0⤊ 0⤋
be sure you tightend it enough. if so the arm may be stripped out enought that the arm may need to be replaced.
id put some elbo grease into it again. and see what happens.
2007-04-19 14:34:22 · answer #3 · answered by FLYC3 3 · 0⤊ 0⤋
Try and tighten again. It must still be loose, good luck
2007-04-19 14:28:44 · answer #4 · answered by Fordman 7 · 0⤊ 0⤋