any place in singapore to recommend where i can get well-trained personnels to do that?contact info will be good.Thanks
2007-04-08 19:11:31 · 4 answers · asked by gtfdynamic 1 in Home & Garden ➔ Do It Yourself (DIY)
i hate when that hapens mate! if possible you could drill the screw out with a 5mm drill and re-tap the hole 6mm,or if you are careful you could drill it 4mm and re-tap it 5mm(this all depends if it into a blind hole or the type of metal the screw is made of.if all fails,just drill it through and use a bolt and nut.hope you get it sorted ,remember these things are sent to try us!
2007-04-12 07:23:02 · answer #1 · answered by davy m 1 · 0⤊ 0⤋
You can use an "Easy Out". A sort of tap/die set that binds up the screw and twists it out. You can also drill it out with a slighly smaller size drill bit. The outside bits normally fall off the old threads. Good luck.
2007-04-09 02:25:17 · answer #2 · answered by Tallulla 1 · 1⤊ 1⤋
Do what Tallula says. Try easy out first, then the latter.
2007-04-11 00:54:36 · answer #3 · answered by JC` 3 · 0⤊ 0⤋
Try a machine shop. They should be able to handle it.
2007-04-09 02:21:00 · answer #4 · answered by Fordman 7 · 0⤊ 1⤋