Can I tile the front of a fiberglass bath tub?

Question

I have a travertine floor in my bathroom. I'd like to build a tub surround by just tiling the sides the tub. I've been told it can't be done because it won't stick and the sides are unstable.

Answer 1

I agree with Steven W. Use Liquid Nails. They stick really well, but I guess you'd have to use quite a lot of it. Then for the grouting, just use white silicon between the tiles. Can't really visualise what you want to do but the above will at least take care of the expansion/contraction of the fibreglass.

Answer 2

There are mortar additives that can use instead of water, and tile will bond. But I still wouldn't do it. First fiberglass will flex, and the at least the grout will crack, and the mortar even with the additive can only flex so far, before the mortar will lose the bond with the fiberglass. Second, it will look worse than the fiberglass. Tile should set on flat substrate. There will lippage. Finally, mortar on vertical surfaces can be messy. It's not too bad if you clean as you go, but you would have use the additive, and I'll tell, I've used it, it sticks to any surface, and doesn't come off, including hands, floors, tubs. If the problem is you don't like the tub, stains, or color, look in to having resurfaced. If you really want a tile tub, rip the old tub out and start new. If you want a tile shower I recommend this system.

http://www.schluter.com/8_4_kerdi_shower_kit.aspx

Ask a tile wholesaler. Don't go to Home Cheapo on this one.

Answer 3

I Think i understand. Move the tub inplace were u want it. Scribe the wall top of tub to the wall Slide tub out the lip that u want to hide cut the wall with a circular saw the depth u want concealed with a razor knife cut the sheetrock tape in the corner then knock the sheetrock off now if i understood u wanted 2 inches mark the studs 2 inches in an plumb down to the floor. Cut this out or how ever far u want it recessed clean up push tub back into the recess bring tile down to tub an u r done if u need 2 inches an only have a three an a half inch stud u may want to only take out one inch then let the backer board an tile make up the rest if u have a 2 by 6 wall roll on hope this helped in the bus. 32 yrs

Answer 4

I've installed a bunch of tile in my life, and have to agree with Fordman.

Certainly you can try "Liquid nails" rather than thin set mortar, or you can face the tub surround with concrete backer board, install tile over that and perhaps do a bull nose on top.

The time, effort, and expense wouldn't be prohibitive and if it doesn't work, I promise not to say "I told you so."

Steven Wolf

Answer 5

fiberglass expands and contracts. That would cause your grout to crack and even the tiles ot become loose.

there is an old saying, "There is never time to do it right, but there is always time to do it over."

If you do it right then its done and you can move on to other exciting projects, do it wrong and it will decrease the value of your house and make it hard to sell, when you decide to.

Answer 6

Hell, I'd try it...Then again, I'm notorious for making things work that I'm told are "impossible"...As my bf says, "Nailing a live octopus to a wall is impossible. Anything else is merely difficult."

Answer 7

anything is possible