lunati cam, roller rockers, I got it with these installed.. fairly large grind I suspect. also suspect it is not roller lifters I am pulling the pressins out fairly quickly so I need to go to screw in studs.. I REALLY dont want to pull the heads... HELP! lol
2007-04-06 07:08:06 · 3 answers · asked by fogrocker 1 in Cars & Transportation ➔ Maintenance & Repairs
I do this all the time, no need to pull heads.
to remove press in rocker studs just use a spacer or washers on the stud then tighten a nut on to draw stud out. after removing stud tap hole and install threaded stud.
I usually put duck tape around stud boss to catch metal from tapping then clean up.
2007-04-06 07:46:29 · answer #1 · answered by Sundew 4 · 0⤊ 0⤋
Just spend a few buck for a bottom tap set first, so the threads don't wind up too tapered.
2007-04-06 10:14:57 · answer #2 · answered by Nomadd 7 · 0⤊ 0⤋
as long as you make sure none of the metal chips fall down the push rod hole ..tap the hole and screw in the stud
a gob of grease will keep the chips stuck to the tap
2007-04-06 07:16:29 · answer #3 · answered by Anonymous · 0⤊ 0⤋