I don't know much about connections to the power button. I'm sure that's where the problem is. My motherboard, monitor and power lead all work fine as I checked them on another computer. Could you please explain in english not IT terms as I don't know that much. The computer was working half an hour ago untill I opened it to add a slave hard drive. Thanks in advance.
2007-04-04 20:07:18 · 2 answers · asked by Rastafarianhobo 4 in Computers & Internet ➔ Hardware ➔ Desktops
take the slave drive off and try booting again. when u put the slave drive on did u unplug any cables from any of the other drives already in the case? if so you may have cause a conflict in the configuration of the devices already installed. add me to yahoo messenger, and i'll help ya ok?
2007-04-04 20:11:51 · answer #1 · answered by sadeyzluv 4 · 1⤊ 0⤋
Disconnect the Slave drive, and re-boot.
If your PC boots, check the jumper settings on the Slave and re-connect..
OR
Read the Motherboard Manual, and look for a reference to: "Motherboard Intrusion Detection".
2007-04-04 20:13:32 · answer #2 · answered by ELfaGeek 7 · 0⤊ 0⤋