I have a StreetGlow Multi-Color LED Wheel-Well Kit, and I originally had a Problem with one of the Tubes. I found the Problem, and Carfully took apart One end of the Tube & Successfully fixed it.
Because I pulled out one of the Sealed ends, I need to make sure that it is still Sealed, and Water Proof!! I didn't 'Break' the actual material that Seals the end, I just pulled it out to connect a disconnected Wire. The material appears to be similar to Glue-Gun type glue, but it is Sticky. It was still sticky when I re-Assembled the Tube.
I was wondering if their was Anyone out there that has ever took apart a StreetGlow LED Tube, and re-assembled & Resealed it. ??
So, do I need to Re-seal my Tube?!?
If I DO need to Re-seal my Tube, then what is the Best way to do so?!? What kind of Glue is best Suitable for a StreetGlow Tubes?!?
Any Tips or Advice would be Very Helpful!!
2007-03-30 17:46:27 · 3 answers · asked by Diog 3 in Cars & Transportation ➔ Maintenance & Repairs
dont know enough about the substrates or the shape, so a general answer is a urethane or an acrylic. something with low durometer for flexibility and adhesion.
2007-03-31 12:11:21 · answer #1 · answered by gnsnfnrs1 3 · 0⤊ 0⤋
I would guess, and it is a guess, using a 2 part epoxy glue would hold up against anything you could throw at it.
I would think you would need to reseal, since this will be in the wheel well and will get snow, rain, a lot of dirt, and who knows what else on it.
good luck
2007-03-31 00:52:24 · answer #2 · answered by Fordman 7 · 0⤊ 0⤋
yes any adhesive will work it is just a sealant to keep out water. just get any auto gasket sealant
2007-03-31 00:53:40 · answer #3 · answered by jsn_ayers 4 · 0⤊ 0⤋